HOW to Light Your GAS Grill

4.For systems other than self-contained LP gas (propane) sys- tems:

A.The grill and its individual shut-off valve must be discon- nected from the gas supply piping system during any pressure testing of that system at test pressures in excess of 1/2 psig (3.5kPa).

B.The grill must isolated from the gas supply piping system by closing its own manual shut off valve during any pressure testing of the gas supply piping system at pressures equal to or less than 1/2 psig (3.5kPa).

5.After the installation of all gas-related items: i.e. hose, regulator, LP gas cylinder, natural gas hose or natural gas regulator; the grill control valves should be turned off and the gas turned on. This is known as "charging the system." All gas connections must be checked with a soapy solution while the whole system is under pressure.

To make a soap solution, mix together an equal amount of liquid detergent and water.

6.Apply soap mixture to all gas connections. Soap bubbles will appear if there is a leak. Tighten connections to make a proper seal.

If you cannot stop a gas leak turn off the gas supply and call your local gas utility, or the dealer from whom the grill was purchased.

Only those parts recommended by the manufacturer should be used on the Superb gas grill. Substitutions will void the war- ranty. Do not use the Superb gas grill until all connections have been checked and do not leak.

A gas system MUST be tested yearly, or whenever the LP gas cylinder is replaced, or any other gas system part.

ADJUSTING FOR PROPER FLAME AND EFFICIENCY Air Shutter (Figure 5)

Each burner is tested and adjusted at the factory prior to shipment. However, variations in the local gas supply may make it necessary to adjust the burners. The flames of the grill burners should be visually checked. The rotisserie burners should have a very low flame (no more than 1/4") and glow with an orange color. There is no air shutter adjustment for the rotisserie burners. On the main burners and side burner, the flames should be blue and stable with no, excessive noise or lifting. If the burners do not operate correctly, check if the air shutter or burner ports are blocked by dirt, debris, spider webs, etc. and proceed with air shutter adjustment. The amount of air which is drawn into a burner is governed by a metal cup at the inlet of the burner called an air shutter.

Figure 5

Air Shutter Adjustment

Be careful as the burners may be very HOT! The air shutters are located behind the valve cover. There is an access area at the bottom of the valve cover where you can adjust the air shutter, with your fingers. A yellow flame indicates insufficient air. Open the air shutter to allow more air to the burner. If flame is noisy, blows out, or lifts away from burner or will not light, this indicates too much air. Close the air shutter.

INSTALLATION CHECK LIST

Note to the Installer: Be sure all items on this list have been thoroughly completed and checked before operating the grill.

1.Specified clearances maintained to combustibles.

2.All internal packaging removed.

3.Knobs turn freely and bezels centered.

4.Each burner lights satisfactorily, individually or with adjacent burner lit.

5.Air shutter adjusted.

6.Adjustable low setting satisfactory.

7.Drip trays in place properly and sliding freely.

8.Pressure regulator connected and set for 11.0" w.c. for LP gas.

9.Pressure checked and set at 3.5" w.c. for Natural gas.

10.Grill tested and free of gas leaks.

11.User informed of gas supply shut off valve location.

WARNING! Before lighting your grill be sure to read this section carefully.

Turn all knobs to the off position. Inspect the gas supply piping or hose prior to turning the gas on. If there is evidence of cuts, wear, or abrasion, it must be replaced prior to use. The replacement pressure regulators and hose assembly must be the type specified by the manufacturer. Do not use the Superb gas grill if the odor of gas is present.

For LP gas, the pressure regulator and hose assembly supplied with the unit must be used. Install the regulator into the tank and check the hose and regulator connections for leakage with a soap and water solution before operating your Superb gas grill. Be sure there is gas in the tank.

When lighting your grill always keep your face and body as far away from the grill as possible.

Lighting the Grill Burners (Figure 6)

The gas grill is equipped with (5) grill burners and (5) piezo ignitors for the grill burners.

Page 6

1.Open the lid.

2.Make sure the grill burner knob to be lighted is in the "OFF" position.

3.Turn ON gas supply to gas grill.

4.Push and turn the grill burner knob to "HIGH."

5.Be certain that you are turning the ignitor for the grill burner you intend on using. Rotate ignitor knob clockwise several times. You will hear a snapping sound, indicating that a spark is being deliv- ered to the burner. You may need to rotate the ignitor knob several times before the grill burner lights.

6.If the grill burner does not light in 4 seconds, turn the grill burner knob to "OFF" and wait 5 minutes before repeating Steps 4 and 5.

7.Each grill burner can also be lit with a match attached to a match holder, if the ignitor fails to light the grill burner.

8.To light with a match attached to a match holder, insert lighted match below valve cover, adjacent to the grill burner knob and through the 1" x 1" square notch on front liner. Turn the grill burner knob to "HIGH." Remove and extinguish the match quickly when the grill burner lights.

R-3848