Step 10
Add fuel scale assembly
You will need: fuel scale assembly, two
Slip the bolts on the back of the fuel scale assembly through the two small holes in the tank panel. Make sure indicator rod of fuel scale is on the left side of the wheel frame.
Add washers then wing nuts and tighten. Figure 12.
| E |
| E |
| F |
| F |
View from front left | View from front right |
Figure 12
Step 11
Install igniter
Note - The igniter wires are already attached to the Gas Catcher Ignition Chamber and the igniter. This was done to factory test the ignition system.
The igniter lock nut is on the igniter.
Insert the top of the igniter up through the large part of the keyhole in the frame brace. Figure 13 (b). Loosen the igniter lock nut and slide the igniter into the small part of the keyhole. Figure 13 (c). Tighten the igniter lock nut. Figure 13.
Note - If the igniter works loose, carefully tighten the igniter lock nut with an adjustable wrench or pliers.
(a)
Frame brace
(b)
Keyhole in | Igniter lock nut | |
frame brace | ||
| ||
Figure 13 |
| |
| (c) |
Frame brace 
Small part of keyhole in frame brace
14