Step 19
Install Lid
You will need: lid, two hinge pins and two hair pin cotters.
Set the lid in place. Align the hinges at the rear of the barbecue. Insert hinge pins from the outside. Insert hair pin cotters into the small holes in the hinge pins. Figure 25.
Hair pin cotter
Hinge pin
Figure 25
Step 20
Add tool holders, control panel and burner control knobs
You will need: two tool holders, control panel, two Phillips screws/washers, a Phillips screwdriver, and three burner control knobs.
Hook the tool holders over the frame rail. Figure 26.
Set the control panel in place over both frame braces. (Hold the Crossover Ignition button up while setting the control panel in place.) Line up the holes in the control panel with the holes in the inserts in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten. Figure 26 (a).
Push on the burner control knobs. Figure 26 (b).
Insert in
frame brace
(a)
Crossover
Ignition Button
Control panel
Phillips screws/
washers
(b)
Tool holders
Figure 26
19