Safe handling tips for Liquid Propane Gas Cylinders
■Liquid Propane (LP) gas is a petroleum product as are gasoline and natural gas. LP gas is a gas at regular temperatures and pressures. Under moderate pressure, inside a cylinder, LP gas is a liquid. As the pressure is released, the liquid readily vaporizes and becomes gas.
■LP gas has an odor similar to natural gas. You should be aware of this odor.
■LP gas is heavier than air. Leaking LP gas may collect in low areas and prevent dispersion.
■To fill, take the LP cylinder to an RV center, or look up
WARNING: We recommend that your LP cylinder be filled at an authorized LP gas dealer, by a qualified attendant, who fills the tank by weight.
IMPROPER FILLING IS DANGEROUS. WARNING: If you exchange your LP cylinder,
make sure you get a similar tank in return. Your LP cylinder is equipped with a quick closing coupling or type 1 valve and an OPD (Overfilling Prevention Device). Other LP cylinders may not be compatible with your barbecue connection.
■Air must be removed from a new LP cylinder before the initial filling. Your LP dealer is equipped to do this.
■The LP cylinder must be installed, transported and stored in an upright position. LP cylinders should not be dropped or handled roughly.
■Never store or transport the LP cylinder where temperatures can reach 125° F (too hot to hold by hand - for example: do not leave the LP cylinder in a car on a hot day).
Note - A refill will last about 20 hours of cooking time at normal use. The fuel scale will indicate the propane supply so you can refill before running out. You do not have to run out before you refill.
■Treat “empty” LP cylinders with the same care as when full. Even when the LP tank is empty of liquid there still may be gas pressure in the cylinder. Always close the cylinder valve before disconnecting.
CAUTION: When transporting the LP cylinder make sure the plastic dust cover is in place over the valve. This will keep dust and dirt from the threaded portion of the valve.
■Do not use a damaged LP cylinder. Dented or rusty LP cylinders or LP cylinders with a damaged valve may be hazardous and should be replaced with a new one immediately.
Liquid Propane (LP) Cylinder(s)
■The joint where the hose connects to the LP cylinder must be leak tested each time the LP cylinder is reconnected. For example, test each time the LP cylinder is refilled.
■Be sure the regulator is mounted with the small vent hole pointed downward so that it will not collect water. This vent should be free of dirt, grease, bugs etc.
■The LP cylinder and connections supplied with your Weber Gas Barbecue have been designed and tested to meet government, American Gas Association, and Underwriters Laboratories requirements.
Liquid Propane Cylinder requirements
■Replacement LP cylinders supplied by Weber satisfy the above requirements. Check to be sure other cylinders have a D.O.T. certification(1), and date tested(2) is within five years. Your LP gas supplier can do this for you.
(1)
DOT 4BA240
00/01
(2)
If you have questions about spare LP cylinders contact the Customer Service Representative in your region using the contact information sheet provided with your manual.
■All LP tank supply systems must include a collar to protect the cylinder valve.
■The LP cylinder must be a
■The LP cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders of the U.S. Department of Transportation (D.O.T.).
For Canada Only
Liquid Propane Cylinder requirements
WARNING: Replacement LP tanks must match the regulator connection supplied with this barbecue.
Note: Your retailer can help you match a replacement tank to your barbecue
■All LP tank supply systems must include a collar to protect the cylinder valve.
■The LP cylinder must be a
■The LP cylinder must be constructed and marked in accordance with the specifications for LP gas cylinders, T.C.