GAS INSTRUCTIONS
ATTACH PROPANE CYLINDER
Use propane cylinders with a minimum capacity of 4.5 kg and a maximum capacity of 9 kg.
CAUTION: Use cylinders that are marked “Liquid Propane fuel” only.
Connect the hose and the regulator to the cylinder.
Note: Regulator vent hole should be pointed down.
WARNING: The regulator has left hand screw threads. It tightens by turning counterclockwise.
WARNING: No sealant is required on the POL fitting. Do not use pipe dope, tape or any other sealant on the POL fitting or LPG cylinder.
Use your fingers to start the POL fitting in the LPG cylinder valve. Turn nut counterclockwise until tight.
1
WARNING: Do not use a wrench to tighten the connection. Using a wrench could damage the regulator coupling and could cause a leak.
DANGER
Do not store a spare LPG gas cylinder under or near this appliance. Never fill the cylinder beyond 80 percent full. If the instructions are not followed exactly, a fire causing death or serious injury may occur. ◆
Hose
POL fitting nut - | Valve handwheel - |
tighten | |
counterclockwise | close clockwise |
Regulator
CHECK FOR GAS LEAKS
DANGER
Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or flames will result in a fire or explosion which can cause serious bodily injury or death, and damage to property.
Check for leaks by wetting the connections with a soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.
A) Regulator to propane cylinder connection (2).
WARNING: If there is a leak at connection (2), disconnect propane cylinder. Reconnect and retighten connection. If a leak persists after retightening the propane cylinder, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact the Customer Service Representative in your area using the contact information on our web site.
Log onto www.weber.com®.
B) Valve
WARNING: If there is a leak at connection (3) turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact the Customer Service Representative in your area using the contact information on our web site.
Log onto www.weber.com®.
When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.
Note: Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.◆
Regulator vent hole
2
3
WWW.WEBER.COM® 15