TROUBLESHOOTING
PROBLEM | CHECK | SOLUTION |
|
|
|
Burner burns with a yellow or orange flame, in | Inspect Weber® Spider/Insect screen for possible | Clean Weber® Spider/Insect screen. Refer to “ANNUAL |
conjunction with the smell of gas. | obstructions. (Blockage of holes.) | MAINTENANCE”. |
|
|
|
Burner does not light, or flame is low in HI position. | Is Liquid propane cylinder fuel low or empty? | Replace propane cylinder. |
|
|
|
| Is fuel hose bent or kinked? | Straighten fuel hose. |
|
|
|
| Does the burner light with a match? | If you can light the burner with a match, then check the |
|
| ignition system. |
|
|
|
Burner does not light when you push the igniter | Be sure that there is gas flow to the burners by | If match lighting is successful, the problem lies in the |
button. | attempting to match light your burners. Refer to | ignition system. Refer to “MAINTENANCE”. |
| “MANUAL IGNITION”. |
|
|
|
|
| Is there is a fresh battery installed? | Verify that the battery is in good condition and installed |
|
| correctly. Refer to “BEFORE USING THE BARBECUE”. |
|
|
|
| Are the wires connected properly to the ignition box? | Be sure that wires are correctly inserted into terminals on |
|
| ignition box. Refer to “MAINTENANCE”. |
|
|
|
| Is there plastic wrapping around the new battery? | Remove plastic wrapping. Do not confuse this with the |
|
| battery label. |
|
|
|
| Is burner tube positioned too far away from the igniter | Check that the burner tube is positioned correctly to the |
| electrode? | igniter electrode. Refer to “MAINTENANCE”. |
|
|
|
Experiencing | Are you preheating barbecue in the prescribed manner? | Burner on HI for 10 to 15 minutes for preheating. |
m CAUTION: Do not line the cookbox |
|
|
Is the cooking grate heavily coated with | Clean thoroughly. Refer to “CLEANING”. | |
with aluminum foil. | grease? |
|
|
| |
| Is the cookbox “dirty” and not allowing grease to flow into | Clean the cookbox. |
| catch pan? |
|
|
|
|
Burner flame pattern is erratic. Flame is low when | Are burners clean? | Clean burner. Refer to “MAINTENANCE”. |
burner is on HI. Flames do not run the whole length |
|
|
of the burner tube. |
|
|
|
|
|
Inside of lid appears to be “peeling.” | The lid is cast aluminum, not paint. It cannot “peel”. | Clean thoroughly. Refer to “MAINTENANCE”. |
(Resembles paint peeling.) | What you are seeing is baked on grease that has turned |
|
| to carbon and is flaking off. |
|
| THIS IS NOT A DEFECT. |
|
|
|
|
If problems cannot be corrected using these methods, please contact Customer Service Australia - refer to “WARRANTY”.
For more information, log onto www.weber.com®.
WWW.WEBER.COM® 19