Weber 500 LP, 98567 Install manifold bracket, Install tank panel assembly and frame connector

Page 13

Step 8

Install manifold bracket

You will need: manifold bracket

Hook the bracket onto the manifold at approximately the center of the length of the manifold. Place your hand underneath the bracket. Lift the manifold, bracket and cooking box slightly and hook the tab of the bracket onto the frame brace. Figure 9.

Frame brace

Manifold bracket

Figure 9

Step 9

Install tank panel assembly and frame connector

You will need: tank panel assembly, frame connector, two 1/4-20 x 1 3/4 inch bolts, two nylon washers and a 7/16 inch wrench.

Insert the tank panel tabs into the slots in the frame brace. Figure 10.

Slots in frame brace

Frame brace

Tank panel tabs

Figure 10

Slide tank panel up until notch at bottom of panel fits over the cross brace. Insert one bolt with washer through the hole in the bottom of the tank panel, through the wheel frame and into the end of the frame connector. Insert the other bolt with washer through the leg frame and into the other end of the frame connector. Hold the frame connector square and tighten the bolts. Figure 11.

Frame connector

Cross brace

Figure 11

13

Image 13

Contents Spirit 500 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents General Instructions For Installation in CanadaStorage Operating areaCheck package contents AssemblyStep REB Check contents of hardware packs Assemble top frame Assemble wheel frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install tank panel assembly and frame connector Install manifold bracketInstall igniter Add fuel scale assemblySet LP fuel scale MCAUTION Do not remove adjustment wing nut from tank scaleFill LP tank Connect LP tank Check that all burner valves are offCheck for gas leaks MWARNING Do not ignite burners when leak checkingInstall the bottom tray Install Flavorizer Bars and Cooking GratesSlide the bottom tray onto the mounting rails under Cooking box with finger grip toward you. FigureAdd tool holders, control panel and burner control knobs Install LidComplete accessory installation To Extinguish LightingManual Lighting Cooking Periodic CleaningStorage and/or Nonuse Storage and/or NonuseRefilling the LP tank Connecting the filled LP tankRemoval of the LP tank Mix soap and water Open the tank valve. Figure DOT 4BA240 Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMWARNING Do not ignite burners while leak checking Main Burner Cleaning Procedure General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High position11-12 Parts List Page Page Final Word Thanks