Weber 500 LP, 98567 owner manual Assembly, Step, Check package contents

Page 7

Assembly

Step 1

Tools needed

Check package contents

 

Hammer

 

 

Cooking box

 

(assembly)

7/16 open-end or an adjustable wrench

 

Pliers

 

Block of wood

Lid

(assembly)

 

®

 

®

Phillips Screwdriver

 

Supplies needed

Your LP tank is shipped empty for safety. After setting the LP fuel scale you will need to fill it. (See Step "Fill LP tank.")

You will need a soap and water solution to check for gas leaks. (See Step "Check for gas leaks.")

Note - The hardware size of nuts, bolts and screws is given. For example "1/4-20 x 2 inch bolt" means a bolt 1/4 inch in diameter with 20 threads to the inch, 2 inches long. On a small screw for example, "6-32 x 1/2 inch screw" means a number 6 screw, with 32 threads to the inch, 1/2 inch long.

While we give much attention to our products, unfortunately an occasional error may occur. If a part is missing, do not go back to the store. Call the Weber Customer Service Center toll free 1-800-446-1071to receive immediate assistance. Have your owner’s manual and serial number of the barbecue available for reference.

LP tank

Bottom tray

Two cooking grates

LP tank filler adapter

Control panel

7

Image 7
Contents Spirit 500 Series LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageCheck package contents AssemblyStep REB Check contents of hardware packs Assemble top frame Assemble wheel frameInstall tubing plugs Continue frame assemblyAdd front panel Add cooking box Install tank panel assembly and frame connector Install manifold bracketInstall igniter Add fuel scale assemblySet LP fuel scale MCAUTION Do not remove adjustment wing nut from tank scaleFill LP tank Connect LP tank Check that all burner valves are offCheck for gas leaks MWARNING Do not ignite burners when leak checkingCooking box with finger grip toward you. Figure Install Flavorizer Bars and Cooking GratesInstall the bottom tray Slide the bottom tray onto the mounting rails underAdd tool holders, control panel and burner control knobs Install LidComplete accessory installation To Extinguish LightingManual Lighting Storage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseRefilling the LP tank Connecting the filled LP tankRemoval of the LP tank Mix soap and water Open the tank valve. Figure DOT 4BA240 Safe handling tips for LP GasInspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMWARNING Do not ignite burners while leak checking Weber Spider Stopper Guards General MaintenanceMain Burner Cleaning Procedure MCAUTION Do not enlarge the burner ports when cleaningTo reinstall the burners, reverse steps c through g Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High position11-12 Parts List Page Page Final Word Thanks