Weber Silver-C Annual Maintenance, Inspection and Cleaning of the Weber Spider Stopper Guards

Page 31

Annual Maintenance

After a period of nonuse, we recommend that you perform the following maintenance procedures for your safety.

WARNING: Check the hose before each use of the barbecue for nicks, cracking, abrasions or cuts. If the hose is found to be damaged in any way, do not use the barbecue. Replace using only Weber authorized replacement hose. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual.

■Inspect the burners for correct flame pattern. Clean if necessary, following the procedures outlined in the “General Maintenance” section of this manual.

■Check all gas fittings for leaks.

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or flames will result in a fire or explosion, which can cause serious bodily injury or death, and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may have loosened or damaged a gas fitting.

WARNING: Perform these leak checks even if your barbecue was dealer- or store-assembled. You will need: a soap and water solution and a rag or brush to apply it.

To perform leak checks: Make sure all Burners are in the off position. Turn on gas supply.

WARNING: Do not ignite burners while leak checking.

Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form, or if a bubble grows, there is a leak.

Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks.

Check:

1) Hose to manifold connections.

WARNING: If there is a leak at connection (1), re- tighten the fitting with a wrench and recheck for leaks with a soap and water solution.

If a leak persists after re-tightening the fitting, turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual.

2)Manifold to side burner hose connection

3)Side burner hose to side burner connection

4)Valves to manifold connection.

5)Hose to quick disconnect connection.

WARNING: If there is a leak at connections (2,3,4

0r 5), turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual.

When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.

(1)

(2)

(3)

(4)

(5)

Inspection and Cleaning of the Weber Spider Stopper™ Guards

To inspect the Spider Stopper Guards, remove the control panel and look to see if they have dust or dirt on their outside surfaces. If they are dirty, brush off the outside surface of the Spider Stopper Guards with a soft bristle brush (an old toothbrush for example). Check that there are no gaps in the Spider Stopper Guards’ seams or in the fit around the burners or valves. (See Section “General Maintenance.”)

D-5

Page 30 Page 32
Image 31
Page 30 Page 32
Contents Gas Grill Liquid Propane GAS Units only South Hicks Road Customer Service CenterPalatine, IL Contents Building, breezeway or any other enclosed area Intended to be installed in or on recreationalWhen in use. Do not leave unattended Well-ventilated area. Do not use in a garageGenesis Silver-C NG Page Page Page Page Assemble frame Assemble wheel frameAdd back panel Continue frame assemblyComplete frame assembly Add front panelInsert casters Add cooking box assemblyOmmend That this Installation be Done by a Professional Install Gas Supply General Specifications for PipingGas Line Piping Install igniterTest Connections Check that all burner valves are off Install manifold bracketConnect flexible hose to manifold Install the slide out bottom tray Install Lid Right swing-up work surface Install the right end trim piece with tool holdersBoard Do not use the swing-up work surface as a cuttingYou will need side burner Install side burnerShown, do not push the trim piece in all Install the left end trim piece and swing-up workWay and do not add bolts yet Do not use the work surface as a cutting board Install the work surfaceChecking Check for gas leaksTime you disconnect and reconnect a gas fitting Your barbecue was dealer or store assembledRetighten the fitting with a wrench and recheck for Install Flavorizer Bars and Cooking GratesInstalling the warming rack Install the bottom shelfTo Extinguish LightingManual Lighting Lighting only the side burner Lighting the Side BurnerCooking CleaningStorage Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceWeber Spider Stopper Guards General MaintenanceReplacing Main Burners Crossover Ignition System Operations Smell of gas Flame is low when burner is onBurners burn with a yellow or Orange flame, in conjunction withConjunction with the smell of gas Side Burner does not lightFlame is low in High position Flame is very yellow

Silver-C specifications

The Weber Silver-C is a versatile and innovative gas grill that has captured the attention of grilling enthusiasts around the world. Designed with both functionality and user-friendliness in mind, it sets a new standard for outdoor cooking experiences.

One of the main features of the Weber Silver-C is its impressive cooking area. With a spacious grilling surface, it provides ample room for various food items, making it practical for family gatherings and outdoor parties. This model is equipped with a high-performance burner system, which ensures even heat distribution for perfectly cooked meats and vegetables.

The grill utilizes advanced technology with its Porcelain-enamelled cast iron cooking grates. These grates not only retain heat exceptionally well but also create perfect sear marks on your food. Additionally, they are easy to clean, allowing for hassle-free maintenance after each cooking session.

The Weber Silver-C also features a convenient electronic ignition system, ensuring that the grill lights up with just the push of a button. This user-friendly ignition eliminates the need for matches or lighters, making the grilling process faster and more accessible.

Another significant characteristic of the Silver-C is its durable construction. Built with high-quality materials, this grill is designed to withstand the elements, ensuring longevity and resilience. The porcelain-enamelled exterior provides a stunning finish while offering protection against rust and wear.

Heat retention is further enhanced by the grill's hood design, which is crafted to trap heat efficiently. This not only allows for faster cooking times but also makes it possible to smoke, roast, and bake on the grill, adding versatility to your culinary endeavors.

Moreover, the Weber Silver-C includes side tables that provide additional space for food preparation and staging cooked items, further enhancing its usability. The grill also has a built-in thermometer integrated into the lid, allowing users to monitor the internal temperature of their food without needing to lift the lid.

In summary, the Weber Silver-C combines performance, durability, and convenience, making it an ideal choice for both novice and expert grillers. Its advanced technologies, spacious cooking area, and multitude of features make it a standout option in the realm of outdoor cooking, promising delightful grilling experiences year-round.
Top Page Image Contents