Step 8
Add bowl panel, tool holders and CharBin Storage Container
You will need: bowl panel, three tool holders and CharBin Storage Container.
Remove protective plastic covering from bowl panel. Slide the ends of bowl panel under bowl mounting brackets so the ends rest on tabs inside frame. Set the panel in place on top of the frame brace. Figure 8.
Hook the tool holders over the frame rail. There is a cut out on the right side of the front panel to accommodate the tool holders. Figure 8.
Tab
CharBin
Bowl panel
Note: Before sliding the CharBin into place check that the Cooking grate holder is sitting loosely on the frame brace and is conforming to the frame brace.
Figure 9 (a). If it is tight or stuck over the edge of the frame brace, Figure 9 (b), reposition as in Figure 9 (a).
If the Cooking grate holder is not correctly positioned, it could allow the CharBin to slide through the frame.
Slide CharBin down into the top frame with the deep end toward the rear. Figure 9.
Inside of | (a) | |
Frame Brace | ||
| ||
Cooking grate |
| |
holder |
|
(b)
CharBin
Figure 9
Tool holders
Figure 8
14