Step 6
Install CharBin lid handle
You will need: CharBin lid handle, two 5/8 inch screws and a Phillips screwdriver.
Remove twist tie and protective plastic covering from CharBin lid. Lift open lid. Insert screws through holes from inside of lid into handle. Tighten screws. Figure 6.
Step 7
Install bowl assembly
You will need: bowl assembly, four 1 3/4 inch bolts, eight nylon washers, four aluminum washers, four acorn nuts, 7/16 wrench and pliers.
Set bowl assembly in open end of frame with lid holder to the outside, and align mounting brackets over holes in frame. Figure 7.
Slip a nylon washer on a bolt and insert bolt through bowl mounting bracket and frame. Place a nylon washer then an aluminum washer and acorn nut on end of bolt. Figure 7.
Repeat for the other three bolts. Do not tighten until all four bolts are correctly in place.
CAUTION: Do not overtighten the bolts. Overtightening can fracture the porcelain.
Nylon washers
Aluminum washer
Figure 6
Lid holder
Figure 7
13