Home Automation 53A00-1 INSTALLATION 1Make the cutout for the touchscreen, 2Remove the faceplate

INSTALLATION

1)Make the cutout for the touchscreen

Hold the template (Installation Template – 53A10-1) against the wall so the top edge is at the appropriate height and parallel to the floor. Using a Punch, or similar instrument, punch through the center of each tick mark (+) on the template.

Drill a 1/4" hole at each punch mark. Using a pencil, draw a line around the quadrant of each hole as shown as shown. Carefully cut along the pencil line.

DO NOT OVERSIZE THIS CUTOUT!

Figure 1

2)Remove the faceplate

Remove the faceplate from the touchscreen by grasping the top and bottom edges of the faceplate and carefully lifting it away from touchscreen backbox.

Note: After installation, the faceplate may be removed by placing a flat blade screwdriver in one of the slots on the bottom of the faceplate and gently lifting to release the latch on the respective side. Repeat by using the slot on the opposite side.

FACEPLATE - BOTTOM VIEW

LATCH RELEASE SLOTS

Figure 2

3