Weber Gas Grill manual Continue frame assembly, Install tubing plugs, Add Wrap-around Frame Panel

Continue frame assembly

You will need: leg frame, wheel frame, four 1/2 inch bolts, four nylon washers and a 7/16 inch or adjustable wrench.

Place the leg frame onto the tabs of the left frame. Place the wheel frame onto the tabs of the right frame. The leg tabs must be on the inside of the frames.

Add the washers to the bolts. Insert the bolts into the holes as shown, do not tighten bolts on wheel frame until a later step.

Install tubing plugs

You will need: two tubing plugs and a hammer. Insert tubing plugs into the ends of the leg frame. To fully seat the plugs, you may have to tap them lightly with a hammer.

Add Wrap-around Frame Panel

You will need: wrap around frame panel and a wrench. Place wrap-around frame panel in place:

1)The cut-out tabs should fit between the washer and the frame, as shown.

2)The square cut-out holes fit around the white plugs in the frame as shown

Tighten Bolts with wrench.

Turn the frame over and continue with assembly.

(1)

(2)

B-2