Install Lid
You will need: lid, two hair pin cotters(1) and two hinge pins(2).
Place lid on top of the cooking box. Align the hinges at the rear of the barbecue. Insert hinge pins through the hinges from the outside. Insert hair pin cotters into the small holes in the hinge pins.
(1)
(2)
Install control panel and burner control knobs You will need: control panel, two Phillips screws/ washers, a Phillips screwdriver, and burner control knobs.
1)Set the control panel in place over both frame braces. Hold the Crossover Ignition button up while setting the control panel in place.
2)Line up the holes in the control panel with the holes in the white plastic plugs in the frame brace. Insert screws and tighten with a Phillips screw- driver until snug. Do not overtighten.
3)Push each of the burner control knobs onto their valve.
(1)
(2)
(3)