Check for gas leaks

Connect side burner to manifold WARNING: Make sure gas supply is off.

Connect the side burner hose as follows:

1)Slide back the collar of the quick disconnect on the manifold.

2)Push the male fitting of the side burner hose into the quick disconnect, and maintain pressure. Slide the collar closed.

Quick disconnect will be engaged.

Check to be sure the side burner valve is OFF. Push the side burner control knob down and turn it clockwise. If it doesn’t turn, the valve is OFF. If it does turn, continue turning it clockwise until it stops, then the burner valve is OFF.

(1)

(2)

DANGER

Do not use an open flame to check for gas leaks. Be sure there are no sparks or open flames in the area while you check for leaks. Sparks or open flames will result in a fire or explosion, which can cause seri- ous bodily injury or death and damage to property.

WARNING: You should check for gas leaks every time you disconnect and reconnect a gas fitting. Note - All factory-made connections have been thoroughly checked for gas leaks. The burners have been flame-tested. As a safety precaution however, you should recheck all fittings for leaks before using your Weber Gas Barbecue. Shipping and handling may loosen or damage a gas fitting.

WARNING: Perform these leak checks even if your barbecue was dealer or store assembled. You will need: a soap and water solution, and a rag or brush to apply it.

Note - Since some leak test solutions, including soap and water, may be slightly corrosive, all connections should be rinsed with water after checking for leaks. Make sure side burner is OFF.

Remove the control panel

1)Unscrew the two phillips screws, located on the right edge of the control panel.

2) Take off the burner control knobs.

3) Lift off the control panel.

C-4