WARNING: Do not ignite burners when leak checking.
Check for leaks by wetting the connections with the soap and water solution and watching for bubbles. If bubbles form or if a bubble grows, there is a leak.
Check:
1) Hose to manifold connection.
WARNING: If there is a leak at connection (1), retighten the fitting with a wrench and recheck for leaks with soap and water solution.
If a leak persists after
2)Regulator to cylinder connection.
3)Manifold to side burner hose connection.
4)Side burner hose to side burner connection.
5)Valves to manifold connections.
6)Hose to regulator connection.
WARNING: If there is a leak at connections (2,3,4,5 or 6), turn OFF the gas. DO NOT OPERATE THE BARBECUE. Contact the Customer Service Representative in your region using the contact information sheet provided with your manual. When leak checks are complete, turn gas supply OFF at the source and rinse connections with water.
(1) | (2) |
|
(3)
(4)
(5)
(6)
Reinstall control panel (after checking for gas leaks)
(1)Set the control panel in place over both sides of the frame. Hold the crossover ignition button up while setting the control panel in place.
(2)Line up the control panel with the white plastic plugs in the frame brace. Insert screws and tighten with a Phillips screwdriver until snug. Do not overtighten.
(3)Push each of the burner control knobs onto their valve.