Weber 3200 owner manual Continue frame assembly, Complete frame assembly, Insert casters

Page 11

Step 4

Continue frame assembly

You will need: frame assembly, wheel frame assembly, front panel, caster frame, four 1/4-20 x 1/2 inch bolts, four nylon washers and a 7/16 inch wrench.

Place the caster frame onto the tabs of the left frame with the dimple to the inside. Figure 3. Place the wheel frame onto the tabs of the right frame with the dimple to the inside. The fuel scale decal should face away as shown. Figure 3.

The leg tabs must be on the inside of the frames.

Add front panel with the hole down and to your right. Add the washers to the bolts, insert in the holes as shown. Only start the bolts at the wheel frame, figure 3 (a) & (b), and tighten the bolts at the caster frame.

Note - Fuel scale decal on wheel frame must be on the same side as the front panel.

Dimples to the inside

Caster frame

Fuel scale decal

Wheel frame

Step 5

Complete frame assembly

You will need: partial frame assembly, two frame connectors, four 1/4-20 x 2 inch bolts, four nylon washers and a 7/16 inch wrench.

Hold one frame connector between the caster and wheel frame. Add nylon washer to the bolts. Put the bolts through the frame and screw into frame connector. Tighten.

Repeat procedure with the other frame connector. Figure 4.

Figure 4

Step 6

Insert casters

You will need: frame assembly and two casters.

(a)

(b)

Push the casters firmly into the inserts in the ends of the caster legs. Figure 5.

Only start these bolts

Figure 3

Figure 5

11

Image 11
Contents Skyline LP GAS Units only MDANGER MWARNINGSWarranty Patents and Trademarks Contents Operating area For Installation in CanadaGeneral Instructions StorageStep AssemblyCheck package contents BER E W REB Check contents of hardware packs Assemble frame Assemble wheelsInsert casters Continue frame assemblyComplete frame assembly Add cooking box Install side burner locksWing nuts Cross brace Install tank panel assemblyCheck that all burner valves are off Install igniterAdd fuel scale MWARNING Make sure gas supply is OFF Install side burnerInstall manifold bracket Fill LP tank MCAUTION Do not remove adjustment wing nut from tank scaleSet LP fuel scale Connect LP tank MWARNING Do not ignite burners while leak checking Check for gas leaksInstall the bottom tray Install Flavorizer Bars and Cooking GratesInstall control panel and burner control knobs Install the lidMCAUTION Make sure both locks have snapped into place Install the condiment basketSecure side burner Install swing table Complete accessory installation MWARNING Do not lean over open barbecue. Keep LightingTo Extinguish Manual Lighting Lighting only the side burner. Figure Lighting the side burnerStorage and/or Nonuse Periodic CleaningCooking Storage and/or NonuseRemoval of the LP tank Connecting the filled LP tankRefilling the LP tank Male fitting Regulator Collar Quick disconnect engaged Liquid Propane LP Tanks Safe handling tips for LP GasDOT 4BA240 Inspection and Cleaning of the Weber Spider Stopper Guards Annual MaintenanceMain Burner Flame Pattern General MaintenanceMCAUTION Do not enlarge the burner ports when cleaning Weber Spider Stopper GuardsView from behind cooking box Wing nuts Crossover Ignition System Operations MCAUTION Do not line the bottom tray with aluminum foil Burner does not light, or flame is low in High positionSide Burner Maintenance Side Burner TroubleshootingPage 16-17 19-20,17 Parts List Final Word Thanks
Related manuals
Manual 40 pages 53.41 Kb