| MAIN & SMOKER BURNER TROUBLESHOOTING | 25 |
| ||
|
|
|
|
|
|
|
|
|
|
|
|
| PROBLEM | CHECK | CURE |
|
|
|
|
|
|
|
|
| Burners burn with a yellow or orange | Inspect Spider / Insect Screens for possible | Clean Spider / Insect Screens. (See Section |
|
|
| flame, in conjunction with the smell of gas. | obstructions. (Blockage of holes.) | “Annual Maintenance”) |
|
|
|
|
|
|
|
|
| Burners do not light. | The excess fl ow safety device, which is part of | To reset the excess fl ow safety device turn all |
|
|
| small flickering flame in the HIGH position. | the barbecue to cylinder connection, may have | burner control knobs and the cylinder valve OFF. |
|
|
| activated. | Disconnect the regulator from the cylinder. Turn |
|
| |
| Barbecue temperature only reaches 250˚ to |
| burner control knobs to HIGH. Wait at least 1 |
|
|
| 300˚ in the HIGH position. |
| minute. Turn burner control knobs OFF. Reconnect | ||
|
|
| the regulator to the cylinder. Turn cylinder valve on | ||
|
|
| slowly. Refer to “Lighting Instructions”. |
|
|
|
|
|
|
|
|
| Burner does not light, or flame is low in | Is LP fuel low or empty? | Refi ll LP cylinder. |
|
|
| HIGH position. |
|
|
|
|
|
| Is fuel hose bent or kinked? | Straighten fuel hose. |
|
|
|
|
|
|
|
|
|
| Does the Left burner light with a match? | If you can light the Left burner with a match, then |
|
|
|
|
| check the Crossover® ignition system. |
|
|
| Experiencing | Are you preheating barbecue in the prescribed | All burners on high for 10 to 15 minutes for |
|
|
|
| manner? | preheating. |
|
|
|
|
|
|
|
|
|
| Are the cooking grates and Flavorizer® bars | Clean thoroughly. (See Section “Cleaning”) |
|
|
|
| heavily coated with |
|
|
|
| CAUTION: Do not line the bottom tray |
|
|
|
|
| with aluminum foil. | Is the bottom tray “dirty” and not allowing | Clean bottom tray |
|
|
|
| grease to fl ow into catch pan? |
|
|
|
|
|
|
|
|
|
| Burner flame pattern is erratic. Flame is | Are burners clean? | Clean burners. (See Section “Maintenance”.) |
|
|
| low when burner is on HIGH. Flames do not |
|
|
|
|
| run the whole length of the burner tube. |
|
|
|
|
|
|
|
|
|
|
| Inside of lid appears to be “peeling.” | The lid is stainless steel, not paint. It cannot | Clean thoroughly. (See Section “Cleaning”.) |
|
|
| (Resembles paint peeling.) | “peel”. What you are seeing is baked on |
|
|
|
|
| grease that has turned to carbon and is fl aking |
|
|
|
|
| off. THIS IS NOT A DEFECT. |
|
|
|
|
|
|
|
|
|
If problems cannot be corrected by using these methods, please contact the Customer Service Representative in your area using the contact information on our web site. Log onto www.weber.com®.