Weber 43267 manual BUILT-IN Cutout Dimensions

Page 2

2

warnings

mDANGER

Failure to follow the Dangers, Warnings and Cautions contained in this Owner’s Manual may result in serious bodily injury or death, or in a fire or an explosion causing damage to property.

mWARNINGS

mDo not store a spare or disconnected liquid propane cylinder under or near the barbecue.

mImproper assembly may be dangerous. Please carefully follow the assembly instructions in this manual.

mDo not operate the Weber® gas barbecue if there is a gas leak present.

mDo not use a flame to check for gas leaks.

mCombustible materials should never be within 24 (60.96cm) inches of the top, bottom, back or sides of your Weber® gas barbecue.

mDo not put a barbecue cover or anything flammable on, or in the storage area under the barbecue.

mYour Weber® gas barbecue should never be used by children. Accessible parts of the barbecue may be very hot. Keep young children away while it is in use.

mYou should exercise reasonable care when operating your Weber® gas barbecue. It will be hot during cooking or cleaning and should never be left unattended, or moved while in operation.

mLiquid propane gas is not natural gas. The conversion or attempted use of natural gas in a liquid propane unit or liquid propane gas in a natural gas unit is dangerous and will void your warranty.

mDo not attempt to disconnect any gas fitting while your barbecue is in operation.

mKeep any electrical supply cord and the fuel supply hose away from any heated surfaces.

mDo not use this Weber® tank enclosure kit unless all parts are in place. The unit must be properly assembled according to the instructions outlined in the “Assembly Instruction” section of the Owner’s Guide.

mProposition 65 Warning: Handling the brass material on this product exposes you to lead, a chemical known to the state of California to cause cancer, birth defects or other reproductive harm.

(Wash hands after handling this product.)

LIQUID PROPANE GAS UNITS ONLY:

mUse the regulator that is supplied with your Weber® Tank Enclosure Kit.

mDo not attempt to disconnect the gas regulator or any gas fitting while your barbecue is in operation.

mA dented or rusty liquid propane cylinder may be hazardous and should be checked by your liquid propane supplier. Do not use a liquid propane cylinder with a damaged valve.

mAlthough your liquid propane cylinder may appear to be empty, gas may still be present, and the cylinder should be transported and stored accordingly.

mIf you see, smell or hear the hiss of escaping gas from the liquid propane cylinder:

1.Move away from liquid propane cylinder.

2.Do not attempt to correct the problem yourself.

3.Call your fire department.

BUILT-IN CUTOUT DIMENSIONS

LOCATING YOUR GRILL

When determining a suitable location for your Summit® gas grill installation, give attention to concerns such as exposure to wind, proximity to traffic paths, and keeping any gas supply lines as short as possible. Never locate the Summit® gas grill in a garage, breezeway, shed, under an unprotected overhang, or other enclosed area. Locate the grill and structure so there is enough room to safely evacuate the area in case of a fire.

CLEARANCE FROM SURFACES OR STRUCTURES

mWARNING: Clearance from any surface or structure is 24 inches (609.6 mm) from the back and sides of the grill. Refer to “Typical Gas Supply Installation” before starting installation.

mWARNING: The structure, “island”, countertops, and adjacent work areas for the built-in grill installation must be built from noncombustible materials only.

NOTE: If you have questions on what materials are considered noncombustible, contact your local building materials supplier or fire department.

1

1

1

2

a

b

 

Clearances

1

24 inches (610 mm) Any Surface

2

 

 

27 inches (685.8 mm) min. for lid clearance

aGrill Frame

bNote: For a countertop treatment: Recommended 3/4" (19.1 mm) overhang. Notch front edge for frame to fully slide in.

www.weber.com®

Image 2
Contents Gas Grill BUILT-IN Cutout Dimensions Island Structure Configuration Options 460 660 Tolerances General construction detailsParts List Parts List Assembly Assembly Back Assembly Assembly 6.35 mm Drill Bit Assembly 14ASSEMBLY Requires 3 D alkaline batteries Included. Use alkaline Assembly 460 660  Attention 460 660 460 660 460 660 460 660 Assembly S-46023 Built-in gas line locations Typical bulk propane gas supply InstallationGeneral Specifications for Piping GAS Supply Test connectionsTypical 20 LP propane gas supply Installation Operating Enclosure Chart Parts List / Assembly Mounting the LP tank Bracket Mounting the LP hose and regulatorConnection chart Connect gas supplyWEBER-STEPHEN Products CO