Weber 42090 manual Lighting, Explosive flame-up, which can cause serious bodily

Operating Instructions

Lighting 1

Summary lighting instructions are on the control panel.

	DANGER	4,5,8
Failure to open the lid while igniting the barbecue’s
burners, or not waiting 5 minutes to allow the gas to
clear if the barbecue does not light, may result in an
explosive flame-up which can cause serious bodily		7
injury or death.
Crossover® Ignition System
Note - The Crossover® ignition system ignites the set of left		2
burners with a spark from the igniter electrode inside the		6
Gas Catcher™ ignition chamber. You generate the energy
for the spark by pushing the electronic ignition button.		2	3
	WARNING: Check hose before each use of
	barbecue for nicks, cracking, abrasions or cuts. If	*The grill illustrated may have slight differences than the
	the hose is found to be damaged in any way, do not
	use the barbecue. Replace using only Weber®	model purchased.
	authorized replacement hose. Contact the
	Customer Service Representative in your region	WARNING: The burner control knobs must be in the
	using the contact information sheet provided with
		OFF position before turning on the liquid propane
	your manual.
		cylinder tank valve. If they are not in the OFF
1)	Open the lid.	position, when you turn on the LP cylinder valve,
		the “excess gas flow control” feature will activate,
2) Make sure all burner control knobs are turned OFF.
		limiting the flow of gas from the LP cylinder. If this
	(Push control knob down and turn clockwise to ensure
		should occur, turn OFF the LP cylinder valve and
	that it is in the OFF position.)
		burner control knobs. Then start over.
	1	DANGER:
		When the “excess gas flow control” feature is
		activated, a small amount of gas is still flowing to the
	4,5,8	burners. After turning OFF the cylinder knobs, wait at
		least 5 minutes for the gas to clear before attempting
		to light the barbecue. Failure to do so may result in an
		explosive flame-up, which can cause serious bodily
	7	injury or death.
		3) Turn the cylinder on by turning the cylinder valve
		counterclockwise.
		WARNING: Do not lean over the open barbecue.

2	4)	Select the burner set you want to operate.
	5)	Push LEFT burner control knob down and turn to
6		START/HI in selected burner set.
	6)	Push igniter button and hold until burner ignites. You
3
		will hear the igniter sparking.
2
	7)	Check that the burner is lit by looking through the
*The grill illustrated may have slight differences than the		cooking grates. You should see a flame.
model purchased.		WARNING: If the burner does not light, turn the
		LEFT burner control knob to OFF and wait 5
		minutes to let the gas clear before you try again or
To Extinguish		try to light with a match.
	8)	After the LEFT burner is lit you can turn on the RIGHT
Push down and turn each burner control knob		burner adjacent to it. The RIGHT burner lights from the
		LEFT burner.
clockwise to the OFF position. Turn gas supply OFF at
the source.

D-3