Step 7
Add cooking box
You will need: frame assembly, cooking box assembly, 1/4- 20 x 2 inch bolt, 1/4 inch nylon washer,
Turn frame assembly right side up.
Uncoil the hose.
Set the cooking box into the frame so the burner tubes are under the frame brace. Figure 6.
Burner tubes
Frame brace
Your Weber Gas Barbecue burner assembly has been factory assembled, pressure and flame tested. As a safety precaution we recommend you check the burner alignment:
a)Do the valves fit into the ends of the burners? Figure 8 (a).
b)Are the ends of the burners under the washers at the left rear and left front of the cooking box? The screws are only guides. Do not tighten. Figure 8 (b).
c)Are the wing nuts under the burner assembly hand tight? Do not tighten with pliers. Figure 8 (c).
If you answered YES to a, b and c, the burners are correctly aligned. If you answered NO, the burners are misaligned. Contact
Guide screw
|
| (b) |
|
| (a) |
| Figure 6 |
|
Slide the cooking box to the left within the frame. Put the |
| |
washer on the bolt. Take the spacer bracket and hold it up | (c) | |
to the frame making sure both tabs fit underneath the |
| |
frame cross piece. Figure 7 (a). Insert the bolt through the |
| |
center hole in the spacer bracket, frame and cooking box |
| |
with the head of the bolt outside the spacer bracket. |
| |
Figure 7 (b). Add keps nut. Figure 7. Tighten by holding |
| |
the bolt with pliers while you tighten the nut with a wrench. | Figure 8 | |
| Frame |
|
| cross piece | Wing nuts |
| (a) |
|
| Spacer bracket |
|
(b) | Keps nut |
|
Tab
Bolt
Nylon washer
Figure 7
12