Check that the igniter is secure in the frame brace and has not shifted out of the key hole. Figure 15.
If it is loose, slide the igniter into the rear of the key hole. Carefully tighten the igniter lock nut with an adjustable wrench or pliers.
(a)
Frame brace
(b)
Keyhole in | Igniter lock nut |
frame brace | |
| (c) |
Frame brace 
Small part of keyhole in frame brace
Figure 15
Check that the tank panel tabs are in their slots in the frame brace. Figure 16.
Tank panel tabs
Figure 16
Check that all the burner valves are off.
Valves are shipped in the OFF position, but you should check to be sure. Put the knob on each valve. Check by pushing down and turning clockwise. If they do not turn, they are off, proceed to the next step. Figure 17.
Figure 17
7