Brinkmann 2610 Series owner manual Trouble Shooting, Problem Possible Causes Burner will not light

TROUBLE SHOOTING:

Problem:		Possible Causes:
• Burner will not light	1.	Check LP cylinder fuel level.
	2.	Bad electrode spark.
		Check to see if the grill will “match light.” (See Page 9)
		Electrode or collector may need adjustment.
	3.	Burner may not be properly seated.
	4.	Burner may be obstructed.
	5.	The cylinder valve may be closed.
	6.	Regulator is not properly seated on cylinder valve.
• Fire at control knobs	1.	Burner holes may be obstructed. See section on
		Cleaning and Maintenance of the Burner holes.
	2.	Burner is improperly seated on control valve.
	3.	Gas connections may be loose.
		Leak Check and tighten all connections.
• Yellow Flames at burner	1.	Burner is obstructed. See section on
		Cleaning and Maintenance of the Burner.

•Flame blows out on “LOW”1. Burner holes may be obstructed. See section on Cleaning and Maintenance of Burners.

2.Grill is not sufficiently preheated.

3.Burner is improperly seated on control valve.

•Burner does not get hot enough 1. Flow control device has been activated in regulator.

2.Turn off grill and the fuel supply. Disconnect grill from cylinder valve. Reconnect grill to cylinder and light grill. See section on Connection to the LP Cylinder.

• Grill is Too Hot	1.	Excess grease build-up causing grease fires.
	2.	Damaged or faulty regulator.
		Replace with Brinkmann parts.
	3.	Cook on a lower temperature setting.

15