Brinkmann Series 4445 owner manual Match Lighting the Side Burner, Turning OFF the Grill

Page 13

MATCH LIGHTING THE SIDE BURNER:

1.Open the lid to the side burner before lighting.

2.Make sure control knob is in the "OFF" position.

3.Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.

4.Turn the side burner control knob to the "HIGH" position. The burner should light immediately.

5.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.

6.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.

NOTE: Observe flame height when lit: Flame should be a Blue/Yellow color between 1"– 2" when burner is on "HIGH”.

TURNING OFF THE GRILL:

1.Turn off the cylinder valve.

2.Turn all burner control knobs to the "OFF" position.

2"

1"

0"

NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure.

CAUTION!

The cylinder valve should always be in the off,

or closed, position when the grill is not in use.

To turn off the cylinder valve, turn knob clockwise until it stops.

12

Image 13
Contents Elite Series For Your Safety Important SafetyTable of Contents General Warnings LP GAS Cylinder not Supplied with this Grill Installation InformationCylinder Specifications Regulator Resetting Procedure Installing the LP GAS Cylinder Onto the GrillFilling the LP GAS Cylinder Hose and RegulatorConnecting Hose and Regulator Connecting Hose and Regulator to AN LP GAS CylinderWhen to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Main Burners Lighting InstructionsMatch Lighting the Main Burners Match Lighting the Rotisserie Burner Lighting the Rotisserie BurnerLighting the Side Burner Turning OFF the Grill Match Lighting the Side BurnerBreaking in Your Grill Operating the GrillPreheating the Grill Controlling FLARE-UPSSide Burner Rotisserie CookingGrilling to Proper Temperature CleanlinessHelpful Hints Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceHeat Distribution Plates Cooking GrillsTransporting and Storage Before Storing Your GrillTrouble Shooting Frequently Asked Questions Frequently Asked Questions Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts BAG Contents Step Tank Tray Assembly Grill Body Assembly Step Attach the door handles using two M4 X 40mm bolts Step Tool Drawer Remove two bolts and washers Step Step Elite Series 4445 Assembled Warranty