Brinkmann Series 4445 owner manual Tank Tray Assembly

Page 26

NOTE: With the help of a friend, turn the cart to its upright position.

Step 4

Place tank tray assembly over vent holes in bottom cart panel and secure using four M6 X 15mm bolts. Tank tray should slide in and out of cart freely.

Step 5

Install door bracket using four

M6 X 50mm bolts. Make sure the door stop is set toward back of cart. (Hand tighten only at this point.)

Tank Tray Assembly

Center Cut-out

Cylinder Clamp

Step 6

Attach the grease cup bracket onto the back panel by inserting the three tabs into the slots on the back cart panel.

25

Image 26

Contents Elite Series Important Safety For Your SafetyTable of Contents General Warnings Installation Information LP GAS Cylinder not Supplied with this GrillCylinder Specifications Filling the LP GAS Cylinder Installing the LP GAS Cylinder Onto the GrillRegulator Resetting Procedure Hose and RegulatorConnecting Hose and Regulator to AN LP GAS Cylinder Connecting Hose and RegulatorChecking for Leaks Leak TestingWhen to Perform a Leak Test PRE-START Check List Match Lighting the Main Burners Lighting InstructionsLighting the Main Burners Lighting the Side Burner Lighting the Rotisserie BurnerMatch Lighting the Rotisserie Burner Match Lighting the Side Burner Turning OFF the GrillPreheating the Grill Operating the GrillBreaking in Your Grill Controlling FLARE-UPSRotisserie Cooking Side BurnerHelpful Hints CleanlinessGrilling to Proper Temperature Cleaning and Maintenance Burner ASSEMBLY/MAINTENANCETransporting and Storage Cooking GrillsHeat Distribution Plates Before Storing Your GrillTrouble Shooting Frequently Asked Questions Frequently Asked Questions Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts BAG Contents Step Tank Tray Assembly Grill Body Assembly Step Attach the door handles using two M4 X 40mm bolts Step Tool Drawer Remove two bolts and washers Step Step Elite Series 4445 Assembled Warranty