Brinkmann Backyard Kitchen owner manual Connecting Hose and Regulator to AN LP GAS Cylinder

Page 7

WARNING

•Never use your grill without leak testing all gas connections and hoses. See the section on "Leak Testing" in this manual for proper procedures.

WARNING

The pressure regulator and hose assembly supplied with your gas grill is designed to work with an LP gas supply cylinder.

•DO NOT attempt to connect it to any other fuel supply source such as a natural gas line.

•DO NOT use any other pressure regulator/hose assembly other than the one supplied with your grill.

•DO NOT attempt to adjust or repair the regulator. A replacement regulator can be supplied by contacting the manufacturer. The regulator is designed to operate at an output pressure of 11 inches of water column (2.74 kPa).

During assembly and/or replacement of the gas cylinder, keep the gas supply hose free of kinks and/or damage.

Visually inspect the hose assembly prior to each use for evidence of damage, excess wear, or deterioration. If found, replace the assembly before using your grill. Only the manufacturers supplied replacement should be used.

WARNING

CONNECTING HOSE AND REGULATOR TO AN LP GAS CYLINDER

•Insure the tank valve is CLOSED prior to connecting the LP gas cylinder to your grill. Turn the valve knob clockwise to properly close the valve. Read and follow all instructions and warnings on the supply hose safety tags. Read and follow all warnings in this manual concerning the safe use of LP gas cylinders and the hose and regulator before connecting cylinder to grill. Read and follow all warnings on the LP cylinder.

1.Check that the cylinder valve is closed by turning the knob clockwise.

2.Check that the grill’s burner knobs are in the proper OFF positions.

3.Remove the protective plastic cap from the cylinder valve and the connection device.

4.Insert the nipple of connection device into the valve outlet. Insure that the device is centered properly.

5.Turn the large coupling nut clockwise by hand and tighten to a full stop. Take care not to cross thread the coupling nut onto the cylinder valve. Do not over-tighten the knob onto the valve. Do not use tools to tighten connection.

NOTE: If you are unable to make the connection, repeat steps 4 and 5.

6.Check that the hose does not contain kinks, does not contact sharp edges, and does not contact surfaces that may become hot during use.

7.Leak check all fittings before lighting your grill. See section on "Leak Testing" in this manual.

6

Page 6 Page 8
Image 7
Page 6 Page 8
Contents Save this Manual for Future Reference For Your Safety Important SafetyPage Cylinder Specifications Installation InformationPage Filling the LP GAS Cylinder Installing the LP GAS Cylinder Onto the GrillHose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder When to Perform a Leak Test Leak TestingChecking for Leaks PRE-START Check List Lighting the Main Burner Lighting InstructionsMatch Lighting the Main Burner Match Lighting the Side Burner Lighting the Side BurnerTurning OFF the Grill Controlling FLARE-UPS Operating the GrillBreaking in Your Grill Preheating the GrillRotisserie Cooking Indirect CookingSide Burner Transporting and Storage SinkCooler Storage AreaCastings Cleaning and MaintenanceBefore Storing Your Grill HardwareCooking Grills Trouble ShootingCeramic Briquets Grilling to Proper Temperature CleanlinessHelpful Hints Assembly Instructions For Missing PARTS, Please Call Customer Service AT Parts BAG Contents Step Casters Add face panel using four stainless steel sheet metal screws Slide baskets into slots located on inside of doors Venturi Tubes Step Orifice inserted into Venturi Tube Attach the drain hose to threaded end of the drain Brinkmann Stainless Steel Backyard Kitchen Assembled Accessories Gallon PAN & Basket SET ONE-YEAR Limited Warranty
Top Page Image Contents