Brinkmann 2235 owner manual Match Lighting the Side Burner, Turning OFF the Grill

Page 13

LIGHTING THE SIDE BURNER:

1.Open lid before lighting side burner.

2.Make sure control knob is in the "OFF" position.

3.Push and turn side burner control knob to the "HIGH" position.

4.Press the electronic igniter on the main control panel and

hold for 3–5 seconds to light burner.

5. If ignition does NOT occur in 5 seconds, turn control knob to "OFF”, wait 5 minutes to allow gas to dissipate and repeat lighting procedure.

6.To turn off, turn each control knob clockwise until it locks in the "OFF" position.

NOTE: If burner does not light or flame is too low, you may have spider or other insect blockage in burner, or the flow limiting device has been activated. See "Burner Assembly/Maintenance" under Proper Care and Maintenance, or "Regulator Resetting Procedure" under Connecting LP Cylinder and Hose/Regulator to Grill.

MATCH LIGHTING THE SIDE BURNER:

1.Open the lid to the side burner before lighting.

2.Turn the burner control knob to "OFF”.

3.Strike and carefully place a match approximately 1/2" (1 to 2 cm) from the burner.

4.Turn the side burner control knob to the "HIGH" position. The burner should light immediately.

5.If the burner does not light, turn the control knob to "OFF" and wait 5 minutes for gas to dissipate and repeat lighting procedure.

6.If the burner does not light within the first few attempts of match lighting, there is a problem with the gas supply. Turn off the gas at the burner and cylinder. DO NOT attempt to operate the grill until the problem is found and corrected. See "Trouble Shooting" section of this manual.

NOTE: Observe flame height when lit: Flame should be a Blue/Yellow color between 1"–2" when burner is on "HIGH”.

TURNING OFF THE GRILL:

1.Turn off the cylinder valve.

2.Turn all burner control knobs to the "OFF" position.

NOTE: Turn off LP cylinder first to prevent gas from being left in the system under pressure.

CAUTION!

The cylinder valve should always be in the off,

or closed, position when the grill is not in use.

To turn off the cylinder valve, turn knob clockwise until it stops.

IMPORTANT FLUATCSMTUOINARENGNNTAKVRDG.AOJUALULVSSSEEVOTAOTMSAFEGUNLHNEVAINSELNT.DRPFOO.EOGDRFAFSARD NLY.

11

Image 13
Contents Gas Outdoor Grill Page For Your Safety Important SafetyTable of Contents General Warnings LP GAS Cylinder not Supplied with this Grill Installation InformationCylinder Specifications Filling the LP GAS Cylinder Regulator Resetting ProcedureHose and Regulator Connecting Hose and Regulator Connecting Hose and Regulator to AN LP GAS Cylinder When to Perform a Leak Test Leak Testing Checking for Leaks PRE-START Check List Lighting the Main Burners Lighting InstructionsMatch Lighting the Main Burners Match Lighting the Side Burner Lighting the Side BurnerTurning OFF the Grill Breaking in Your Grill Operating the GrillPreheating the Grill Controlling FLARE-UPSSide Burner Rotisserie CookingGrilling to Proper Temperature CleanlinessHelpful Hints Burner ASSEMBLY/MAINTENANCE Cleaning and MaintenanceHeat Distribution Plates Cooking GrillsTransporting and Storage Before Storing Your GrillTrouble Shooting Frequently Asked Questions Frequently Asked Questions Parts BAG Contents Assembly Instructions For Missing PARTS, Please Call Customer Service AT Step Hubcap Tank Heat Shield Plate Place grease cup in middle of hole in heat shield plate Grill Body Assembly Hose Heat Shield Step Place side burner grate on side burner Side Burner Igniter Step ProSeries 2235 Assembled Accessories Gallon PAN & Basket SET Warranty