Batteries and Charging
Off-Board Battery Charger
Your scooter is supplied with an
Your battery pack may be charged on or off the scooter.
1.Switch your scooter off at the key switch.
2.Swivel the charge connector cover located on the right hand side of the battery pack and connect the charger
(Photo 12.2).
3.Ensure that the charger plug is dry and intact before connecting it to the mains and switching it on.
4.A reset button is located on the left hand side of the battery pack. Please check that the button is pressed in
(Photo 12.3).
Note:
The charger is capable of charging from 230V or 110V electrical supplies.
The 1.5 Amp,
1.RED = Charger is on.
2.RED / GREEN = Charging.
3.GREEN = Fully charged.
Ensure the scooter is switched off before commencing the charging process.
After charging, always swivel the charging socket cover back into place. This helps prevent water getting into the socket (Photo 12.5).
Please note that the scooter has a safety circuit to prevent it from being driven off during charging. If your scooter fails to respond to normal control after a charging period, please check that the battery charger has been completely disconnected from the scooter.
WARNING.
Do not attempt to charge your scooter outdoors or in damp/wet conditions. Failure to comply with this instruction may lead to a shock / fire hazard.
Photo 12.1
Photo 12.2
Photo 12.3
Photo 12.4
Photo 12.5
12 | Iss 1 |
|
|
|
|