Thinning with a comb attachment

Set the locking ring so the thinning symbol is level with the arrow on the appliance. Thin the hair or the beard by cutting against the growth direction of the hair.

Tips

•Check the required comb attachment is fitted and set to required length.

•Only cut small lengths of hair at a time. Use decreasing settings until you achieve the right length.

o The cutting head will slow down or become blocked if the speed is too fast or if you cut too much hair at a time.

•Hold the appliance with the slanting side of the comb attachment facing the head, and move in slow, even movements through the hair. If necessary, use the scissors (4) and the comb (3).

•Brush the hair cuttings away from the head as you go to see how you progress.

•Regularly shake hair cuttings from the appliance to prevent the cutting head from becoming blocked.

Recharging the batteries

The appliance can be charged directly using the adapter (1) supplied, or can be charged in the holder.

•Connect the small jack at the end the cord (2) to the charging socket underneath the appliance (12) or to the socket on the back of the holder (5) if the appliance is placed in the holder.

•Plug in and switch the power on.

•Check the appliance is switched off (on/off button at 0).

o The charging indicator (11) will show red during charging. The indicator does not switch off when charging is complete but the appliance switches off automatically, as it is protected against overheating.

o Normal charging takes approx. 7 hours.

oThe appliance can run for approx. 40 minutes when fully charged.

CLEANING AND MAINTENANCE

•Brush cutting head and comb attachments using the small cleaning brush (7) after each use.

•Lubricate the cutting head regularly with 1-2 drops of the lubricating oil supplied (6). See "Lubricating the cutting head" below.

•Only wipe the appliance with a dry cloth. Do not use water for cleaning the appliance.

Lubricating the cutting head

•Detach the comb attachment and carefully remove the cutting head by pushing it backwards.

•Press the spring on the cutting head to open it.

•Add 1-2 drops of oil, release the spring to close the cutting head and move it back and forth to distribute the oil.

•Press the cutting head back onto the appliance until it clicks into place.

•Wipe off any excess oil with a cloth.

Caution!

Only use acid-free oil, e.g. sewing machine oil, if the supplied oil runs out.

INFORMATION ON DISPOSAL AND RECYCLING OF THIS PRODUCT

Please note that this Adexi product is

marked with this symbol:

This means that this product must not be disposed of along with ordinary household waste, as electrical and electronic waste must be disposed of separately.