Panasonic CW-XC54HU, CW-XC54HK Electrical Data, HOW to Secure the Drain Pipe, Removal from Window

4. SECURE THE GUIDE PANELS

Extend the guide panels (TYPE F) to fill the window opening using 4 screws (TYPE B) to secure them, as shown in Fig. 12.

5. INSTALL THE SASH SEAL AND SASH LOCK

a. Cut the sash seal (TYPE E) to the window width.

Stuff the sash seal between the glass and the

window to prevent air and insects from getting into

the room, as shown in Fig. 12.

b. Fasten the L bracket using a screw (TYPE A), as

shown in Fig. 12.

6. a. Remove the screws that secure the cabinet and

base pan in the right side.

b. Fasten the support bracket (TYPE G) using a

removed screw. Attach the support bracket (TYPE G)

in the inner window sill with a screw (TYPE B), as

shown Fig. 13.

LBRACKET TYPE A

TYPE B

Fig. 12

TYPE B

SASH SEAL

(TYPE E)

7. Window installation of room air conditioner is now

completed. See ELECTRICAL DATA for attaching

power cord to electrical outlet.

Support Bracket (TYPE G)

Fig. 13

Installation

C. HOW TO SECURE THE DRAIN PIPE

In humid weather, excess water may cause the BASE PAN to overflow. To drain the water, remove the DRAIN CAP and secure the DRAIN PIPE to the rear hole of the BASE PAN. (Fig. 14) Press the drain pipe into the hole by pushing down and away from the fins to avoid injury.

REMOVAL FROM WINDOW

Hang Push

DRAIN PIPE DRAIN CAP

Fig. 14

Features and

Turn the air conditioner off, disconnect the power cord, remove the Support Bracket, L bracket and the screws installed through the top and bottom of the guide panels, and save for reinstallation later. Close the guide panels. Keeping a firm grip on the air conditioner, raise the sash, and carefully tilt the air conditioner backward, draining any condensate. Lift the air conditioner from the window and remove the sash seal from between the windows.

Electrical Data

Line Cord Plug	Use Wall Receptacle	Power Supply
Do not under any
circumstances cut		Use 15 AMP, time
or remove the
grounding prong		delay fuse or circuit
from the plug.		breaker.
Power supply cord with	Standard 125V, 3-wire grounding
3-prong grounding plug	receptacle rated 15A, 125V AC

USE OF EXTENSION CORDS

Because of potential safety hazards, we strongly discourage the use of an extension cord. However, if you wish to use an extension cord, use a CSA certified/UL-listed 3-wire (grounding) extension cord, rated 15A, 125V.

12