➍When the measurement is complete, the cuff completely deflates and your blood pressure and pulse rate are displayed.
NOTE :
The monitor automatically stores blood pressure and pulse rate into the memory.
•When 28 sets of readings are stored in memory, the oldest set will be deleted to store a new set.
➎Press the (O/I) button to turn the monitor off.
NOTE :
If you forget to turn the monitor off, it will automatically shut itself off after five minutes.
How to use the memory function
English
This monitor has a memory capable of storing 28 sets of readings. Every time you complete the measurement, the monitor automatically stores blood pressure and pulse rate.
•Turn on the monitor by pressing the (O/I) button.
•Press the ( 
) button to recall stored readings while the ( 
) symbol is displayed.
START 
Continue to press button
Instructions for special conditions:
•If your systolic pressure is known to be more than 220 mmHg, press and hold the (START 
) button until the monitor inflates 30 to 40 mmHg higher than your suspected systolic pressure.
NOTE :
Do not apply more pressure than necessary.
The monitor will not inflate above 300 mmHg.
Date and Time of stored readings
will be alternately displayed.
•To delete all the stored readings, press the ( 
) button and the (START 
) button simultaneously.
NOTE :
You can not delete the stored readings partially.
START 
Press these two buttons at the same time.
10
11