A&D UA-767, BT-Ci instruction manual Measurements, Normal Measurement

Measurements

Model UA-767 BT-Ci is designed to detect the pulse and to inflate the cuff to a systolic pressure level automatically.

If your systolic pressure is expected to exceed 230 mmHg or you use the optional small cuff, read "Measurement with the desired systolic pressure" on the next page.

Normal Measurement

1.	Place the cuff on the arm (preferably the left arm).					At heart level
	Sit quietly during measurement.
2.	Press the			button.
		START						button
	The last	data of		systolic and diastolic			START
	pressure and pulse rate are displayed					The last data
	briefly. Then the display changes, as
	indicated in the figure at the right, as the					at initial display
	measurement begins. The cuff starts to
	inflate. It is normal for the cuff to feel very					Starts inflation
	tight. A pressure bar indicator is displayed,
	as in the figure at the right, during inflation.
	Note: If you wish to stop inflation at any time,						Pressurizing
	press the				button again.
			START

3.When inflation is complete, deflation starts

automatically and the (heart mark) blinks, indicating that the measurement is

in progress. Once the pulse is detected,			Measurement
the mark blinks with each pulse beat.
				in progress
Note: If an appropriate pressure is not
obtained, the device starts to inflate
again automatically.			Systolic pressure
4. When the measurement is complete, the
			Diastolic pressure
systolic and diastolic pressure readings and
pulse rate are displayed. The cuff exhausts
the remaining air and deflates completely.
				Pulse rate
5. Press the		button again to turn
	START
				Exhausts remaining
off the power.
				air automatically

Note: Model UA-767 BT-Ci is provided with an automatic power shut-off function. Allow at least three minutes between measurements on the same person.

English 12