Unpairing procedure

Using the Monitor

1.Press and hold the displayed.

START

button until “upr” is

2.Press the START performed.

button again. Unpairing will be

3.The monitor displays “end” ” to indicate that unpairing

is complete.

When two receiver devices are paired, both devices are unpaired.

4.If “err10” or “err11” is displayed or unpairing is failed, try steps 1-3 again.

Communication distance

The communication distance between this monitor and the receiver device is dependent on the Bluetooth output class of the receiver device.

When the receiver device is a Class 1 Bluetooth device: Less than 100 m

When the receiver device is a Class 2 Bluetooth device: Less than 10 m

This distance is reduced by the conditions in the surrounding environment, so be sure to check that the distance is short enough for a connection to be made after measurement is complete.

Memory

In cases when the receiver device cannot receive measurement data, the measurement data is temporarily stored in the monitor memory. The data stored in the memory is transmitted the next time a connection is successfully made to the receiver device

A total of 200 sets of measurement data can be stored. When the amount of data exceeds 200 sets, the oldest data is deleted and the new data is stored. The amount of data that can be stored temporarily may vary with the application.

Time

This monitor has a built-in clock. The date and time that a measurement was taken is included in the measurement data.

The built-in clock is designed to be automatically adjusted by syncing with the clock of a receiver device. Refer to the specifications of the receiver device.

This monitor has no clock adjustment function.

English 9