VocoPro KR-3808 PRO owner manual Connecting Speakers, Preparing the Speaker Cable

Getting Connected

Connecting Speakers

The Speaker Terminals are located on the rear panel. There are two STEREO terminals. Be sure to connect the left channel (L), right channel (R), “+” (red) and “--” (black) properly.

����������������������

Preparing the Speaker Cable

You can either used an exposed speaker wire or Banana Plug speaker cable.

Exposed Speaker Wire

1. Remove approximately 3/8” (10mm) of insulation.

����

���������������������

������������������������

�����������������������

����������

��������������

������������������

��������������

WARNING: TO REDUCE THE RISK OF FIRE OR ELECTRIC SHOCK, DO NOT EXPOSE THIS EQUIPMENT TO RAIN OR MOISTURE

CAUTION: TO PREVENT ELECTRIC SHOCK, DO NOT REMOVE COVER SCREWS. NO USER-SERVICEABLE PARTS INSIDE. REFER SERVICING TO QUALIFIED SERVICE PERSONNEL.

����������

��������

110V

220V

THE POWER

SUPPLY CORD

SHOULD BE

DISCONNECTED

BEFORE

CHANGING THE

VOLTAGE

SELECTOR

����

CAUTION: TO REDUCE THE RISK OF FIRE, REPLACE ONLY WITH SAME TYPE FUSE

�������

�����

��������

����������

�������

2.Twist the exposed wires together to prevent short circuits.

•Before connecting the speakers, make sure that the KR- 3808 PRO is disconnected from the power source.

•Do not let the bare speaker wires touch each other or another metal part of this unit. This could damage the KR- 3808 PRO and/or the speakers.

Determining the proper way to connect the speaker cables:

The speaker cable is a pair of insulated cables running side by side. One cable is colored or shaped differently, perhaps with a stripe, groove or ridges.

1.Connect one end of the striped (grooved, ridged, etc.) cable to the “+” (red) terminal on the rear panel of the KR-3808 PRO.

2.Connect the other end of the striped (grooved, ridged, etc.) cable to the “+” (red) terminal on the speaker.

3.Connect one end of the “plain” (NO stripes, grooves, ridges, etc.) cable to the “--” (black) terminal on the rear panel of the KR-3808 PRO.

4.Connect the other end of the “plain” (NO stripes, grooves, ridges, etc.) cable to the “--” (black) terminal on the speaker

�������������

������������

����������

4.Insert the bare wire.

5.Tighten the knob until the wire is secure.

�� �

����������������

Using Banana Connectors

1.Plug the Banana connectors into the speakers, ensuring the black and red connectors are aligned properly.

2.Plug the other ends of the cables into the KR-3808 PRO’s speaker output, ensuring the black and red connectors are aligned properly.

8