1.Mount the bracket using the two center holes. Swivel the sphygmomanometer on its bracket to expose the mounting holes, as shown below.
manometer mounting
screw bracket position on wall
Installation, 222 / V222B
Wallmax Professional
Aneroid Sphygmomanometer
2. Locate the wall stud where you will mount the bracket.
DANGER—risk
3.Hold the bracket up to the wall at the desired mount- ing height. Place the two center mounting holes directly over the wall stud. Ensure that the manometer's face is correctly oriented and that the bracket is level. Mark on the wall in the center of both holes. Remove the bracket.
4.Drill a 3/16" hole approximately 7/8" deep at each of the two marked locations.
5.Hold the bracket up to the wall at the mounting location, ensuring that the manometer's face is correctly oriented and that the bracket is level.
6.Install the two mounting screws through the bracket center mounting holes into the wall stud. Do not over- tighten.
Labtron 222 / V222B Wallmax Professional Aneroid Sphygmomanometer |