Pride Mobility J6 2SP manual Battery Break-in, Frequently Asked Questions FAQs

Page 30

V I . B A T T E R I E S A N D C H A R G I N G

To charge the batteries using the off-board charger: 1. Position the front of your power chair next to a

standard electrical outlet.

2. Be certain the controller power is turned off and the freewheel levers are in the engaged position. See III. “Your Power Chair.”

3. Plug the off-board charger into the off-board charger/ programming socket on the controller. See figure 24.

4. Plug the off-board charger into the electrical outlet.

NOTE: The LED lights on the charger indicate different

charger conditions at various times: charger power on, charging in progress, and charging complete. Refer to the manual supplied with the charger for a complete explanation of those indicators.

5. When the batteries are fully charged, unplug the off- board charger from the electrical outlet and then from the controller.

Figure 24. Battery Charging

Battery Break-in

To break in new batteries for maximum efficiency:

1.Fully recharge any new battery prior to its initial use. This brings the battery up to about 90% of its peak performance level.

2.Operate your power chair throughout the house and yard. Move slowly at first, and do not travel too far until you become accustomed to the controls and break in the batteries.

3.Give the batteries another full charge of 8 to 14 hours and operate your power chair again. The batteries will now perform at over 90% of their potential.

4.After four or five charging cycles, the batteries will top off at 100% charge and last for an extended period.

Frequently Asked Questions (FAQs)

How does the charger work?

The battery charger takes the standard electrical outlet voltage of 120 VAC (alternating current) and converts it to 24 VDC (direct current). The power chair batteries use direct current to run your power chair. When the battery voltage is low, the charger works harder to charge the battery. As the battery voltage approaches full charge, the charger does not work as hard to complete the charging cycle. This explains why the ammeter drops as it approaches a full charge. This is how the charger maintains a charge but does not overcharge the battery.

Can I use a different battery charger?

You should use the charger supplied with the power chair. It is the safest, most efficient tool to charge the batteries. We do not recommend using other types of chargers (e.g., an automotive battery charger).

NOTE: Your power chair’s charger will not operate after the batteries have been discharged to nearly zero voltage. If this happens, call your authorized Pride Provider for assistance.

How often must I charge the batteries?

Many factors come into play when deciding how often to charge the batteries. You may use your power chair all day on a daily basis or you may not use it for weeks at a time.

30

www.pridemobility.com

J6 Series

Image 30
Contents Including Models J6 2S and J6 2SP F E T Y G U I D E L I N E S Quick Reference InformationN T E N T S IIIPURCHASER’S Agreement SafetyN T R O D U C T I O N Shipping and DeliveryProduct Safety Symbols S a F E T YS a F E T Y S a F E T Y Shroud Pre-Ride Safety Check General GuidelinesModifications Weight Limitations Tire InflationIncline Information Freewheel Mode Braking InformationCornering Information Stationary Obstacles Steps, Curbs, etc Inclement Weather PrecautionsPublic Streets and Roadways Outdoor Driving Surfaces To navigate up over a curb or stationary obstacleElevators Stairs and EscalatorsDoors Lift Systems/Elevation ProductsPositioning Belts BatteriesTransfers Prescription Drugs/Physical LimitationsAlcohol/Smoking Electromagnetic and Radio Frequency Interference EMI/RFIJ6 Power Chair I . Y O U R P O W E R C H a I RJ6 Power Base Electrical ComponentsJ6 Electrical Components Manual Freewheel Levers To engage or disengage the drive motorsInitial Assembly A S S E M B L YSeat Installation To install the seatPower Seat Option Installation To install the power seatSeat Height and Seat Angle Adjustment Comfort AdjustmentsYou may need the following to make comfort adjust- ments O M F O R T a D J U S T M E N T SManual Recline Seatback Adjustment Seatback Angle AdjustmentSeat Position Armrest Width Adjustment Armrest Angle AdjustmentController Position To adjust the foot platform depth Foot Platform Height AdjustmentFoot Platform Depth Adjustment To raise or lower the foot platformPower Elevating Seat Optional Foot Platform Angle AdjustmentTo adjust the foot platform angle To change the seat height through toggle switchB a T T E R I E S a N D C H a R G I N G Batteries and ChargingCharging the Batteries Battery Break-in Frequently Asked Questions FAQsInfrequent Use Why do my new batteries seem weak?Daily Use How can I get maximum range or distance per charge?What about public transportation? How can I ensure maximum battery life?How should I store my power chair and its batteries? What about shipping?Temperature Care and MaintenanceShould your power chair come in contact with water I . C a R E a N D M a I N T E N a N C ETo check the brakes Daily ChecksWeekly Checks Monthly ChecksWheel Replacement Disposal of Your Power ChairCleaning and Disinfection StorageSolid Drive Wheel Removal Battery Installation Battery Replacement To replace the batteriesWhen to See Your authorized Pride Provider for Service Corrective MaintenanceI I . W a R R a N T Y Service Checks and Warranty Service Reconditioned Units WarrantyWarranty Exclusions Exclusions also include components with damage caused byP E N D I X I Specification S J6 SpecificationsJ6 Dimensions and Ground Clearance T E S T E S T E S Page Quality Control J6 Product Serial #
Related manuals
Manual 44 pages 34.42 Kb