Pride Mobility I NFMANU339 manual Armrest Width Adjustment, Armrest Angle Adjustment

V . C O M F O R T A D J U S T M E N T S

Armrest Width Adjustment

You can change each armrest’s width independently of the other.

NOTE: Changing the armrest width may increase the overall width of your power chair.

To change the armrest width:

1.Locate the two armrest knobs on each side of the armrest receiver bracket. See figure 12.

2.Loosen the knobs.

3.Slide the armrests in or out to the desired width.

4.Tighten the knobs.

Armrest Angle Adjustment

To change the armrest angle:

1.Lift the armrest straight up so that it is perpendicular to the floor. See figure 13.

2.Loosen the jam nut.

3.Turn the adjustment screw to raise or lower the front of the armrest.

4.Tighten the jam nut to lock the adjustment screw into place.

Armrest Height Adjustment

To change the armrest height:

1.Loosen the setscrews on the armrest. See figure 13.

2.Raise or lower the armrest to the desired height.

3.Tighten the setscrews to secure the armrest.

Controller Position

You can move the controller in toward or out away from the armrest, or change the position of the control- ler for either left-hand or right-hand use.

WARNING! Do not place the controller harness so that it can be pinched in the seat frame or the power base frame.

To extend the controller:

1.Flip up the armrest so it is perpendicular to the floor.

2.Loosen the setscrew on the controller bracket. See figure 13.

3.Slide the controller into or out of the armrest to the desired position.

4.Tighten the setscrew to secure the controller.

ARMREST

KNOBS

Figure 12. Armrest Width Adjustment

CONTROLLER

BRACKET

SETSCREW

JAM NUT

ARMREST

ANGLE

ADJUSTMENT

SCREW

ARMREST

HEIGHT

ADJUSTMENT

SETSCREWS

Figure 13. Armrest Angle and Height Adjustment

Select Traveller www.pridemobility.com 23