Buzzaround XL Owner’s Manual | RevA_092210 |
X. CARE AND MAINTENANCE
NOTE: If the main circuit breaker continues to trip, there is probably an underlying electrical fault that needs attention.
•Contact your authorized Golden Technologies, Inc. dealer.
•Do not keep resetting the main circuit breaker without correcting the underlying electrical problem.
DIAGNOSTICS
The diagnostics feature of your Golden Buzzaround XL microprocessor based motor control board functions as follows:
•Any fault condition with the controller or with an associated system will cause the scooter to beep.
•The number of beeps in each series is referred to as the “Beep Code.”
•The beep code indicates the nature of the condition or fault.
Beep Codes
1 Beep
•Indicates that the battery voltage (with the throttle control lever in the neutral position) is below the required operating voltage of the scooter.
•The batteries need to be charged.
•Your Buzzaround XL will continue to operate at reduced speeds.
•As the voltage drops you will experience a power loss.
Remedy: Charge your Buzzaround XL’s batteries. See “Batteries and Charging” in this section.
2 Beeps
•Indicates that the battery voltage is too low for the scooter to operate.
•At this voltage your scooter will cease operation.
•If you have charged the batteries and the condition continues, one or both of the scooter’s batteries may be at fault.
•The continuance of this condition after you have charged your Buzzaround XL’s batteries may also indicate a problem with the battery charger.
3 Beeps
Consult your authorized Golden Technologies, Inc. dealer.
35