Set up and usage instructions
Unfolding the scooter for first time use.
1 Insert and secure the left and right handlebars by pressing the spring-loaded buttons and inserting them into the T-tube.
4 The Joint lever is spring-loaded and will automatically lock in the upright position when fully upright.
2 Make certain the spring-loaded button engages the hole in the T-bar for each handlebar.
5 To adjust the height of the handlebars, unlock the extension tube by pulling outward on the quick-release lever and pushing the button located on the extension tube. Slide the T-tube to the desired position and secure by pushing inward on the quick release lever.
3 To release the folding mechanism, hold the T-tube with one hand between the collar clamp and the quick-release lever and place your foot on the deck plate. With the other hand, pull the joint lever up to release the steer- ing column from the locked position and allow you to pivot it to the upright position.
6 The tension of the quick-release lever can be adjusted by tightening or loosening the allen bolt. Be care- ful not to over-tighten. You should always be able to open and close the quick-release lever by hand and the T-tube should slide freely with the quick-release open.
WARNING: Failure to properly engage the spring-loaded buttons may cause the handlebars to dislodge while riding and may cause you to lose control and fall. When correctly engaged the handlebars will not rotate nor will they move sideways. Note that when properly engaged, the spring- loaded buttons are clearly visible in the holes on the T-tube.
WARNING: Keep your fingers clear of the pivoting mechanism when folding or unfolding the scooter. Make sure others are standing clear.
Check before riding
Collar Clamp
Using the 5mm Allen wrench, check that the collar clamp bolt is tightened securely. This item is tightened and quality inspected at the factory, but there is a slight chance that the effects of
shipping or handling may have caused this bolt to loosen.
WARNING: Failure to properly engage the quick-release lever may cause the T-tube to side up or down while riding which may cause you to lose control and fall. With the quick-release properly adjusted and engaged, the handlebars will not move up or down.
