Razor E100 owner manual Front Wheel Replacement, Chain and Rear Wheel Replacement

Repair and Maintenance

qFront Wheel Replacement

Tools required: 10mm wrench, two (2) 17mm wrenches and a flathead screwdriver.

1 Using a 10mm open wrench,	2 Using two 17mm wrenches,
loosen the brake cable bolt.	loosen the locknuts by turn-
	ing the wrenches counter
	clockwise. Remove wheel and
	install replacement wheel.

qChain and Rear Wheel Replacement

Tools required: Phillips screwdriver, 10mm wrench, two (2) 8mm wrenches, and two (2) 13mm wrenches.

1 With a Phillips screwdriver,	2 Using two 13mm wrenches,	3 To loosen the chain, push the
loosen the two screws and	loosen the locknuts by turning	tensioner down to create some
remove the chain guard.	the wrenches counter clockwise.	slack in the chain.

4 Remove wheel and install	5 Push the chain tensioner	6 With two 13mm wrenches,
replacement wheel.	down to install the chain on	re-tighten the locknuts.
(Note the sequence of the	both sprockets.
hardware)

7 Re-attach the chain guard.

5

Note: Front wheel hardware sequence

8-1

8-3

8-2 8-2

8-6 8-5

8-1

8-2 8-2

Right Side (Throttle)

8-3 - (Short) spacer

8-2 - Washer

Fork

8-2 - Washer

8-1 - 17mm locknut

Middle

8-6 - Front axle bolt

Left Side (Brake)

8-5 - (Short) spacer

8-2 - Washer

Fork

8-2 - Washer

8-1 - 17mm locknut

Note: Rear wheel hardware sequence

Right Side (Throttle)

18-1 M8 Nut

18-2 Washer (2)

Frame

18-3 Plate cut washer

18-4 (Short) Spacer

Left Side (Brake)

18-1 M8 Nut

18-2 Washer (2)

Frame

18-3 Plate cut washer

18-4 (Long) Spacer