Troubleshooting Guide
Problem | Possible Cause | Solution |
|
|
|
Scooter does not run | Scooter must be traveling 3mph | Kick start to 3mph while twisting the throttle to engage motor. |
| before motor will engage. |
|
| Battery needs a charge | Charge the battery. A new battery should be charged for at least 18 |
|
| hours before using the scooter for the first time and up to 12 hours |
|
| after each subsequent use. |
|
| Check all connectors. Make sure the charger connector is tightly |
|
| plugged into the charging port, and that the charger is plugged into |
|
| the wall. |
| Charger is not working | Make sure power flow to the wall outlet is on. |
Scooter suddenly | Tripped circuit breaker | Check all wires and connectors to make sure they are tight. |
stopped working while |
|
|
in use |
| The circuit breaker (next to on/off switch) will automatically shut off |
|
| the power if the motor is overloaded. |
|
| An excessive overload, such as too heavy a rider or too steep a hill, |
|
| could cause the motor to overheat. If the scooter suddenly stops |
|
| running, wait a few seconds and then push the breaker to reset the |
|
| circuit. Correct the conditions that caused the breaker to trip to avoid |
|
| repeatedly tripping the breaker. |
|
|
|
Short run time (less | Undercharged battery | Charge the battery. A new battery should be charged for at least 18 |
than 15 minutes per |
| hours before using the scooter for the first time and up to 12 hours |
charge) |
| after each subsequent use. |
|
| Check all wires and connectors. Make sure the battery connector is |
|
| tightly plugged into the charger connector, and that the charger is |
|
| plugged into the wall. |
| Battery is old and will not accept | Make sure power flow to the wall outlet is on. |
| full charge | Even with proper care, a rechargeable battery does not last forever. |
|
| |
|
| Average battery life is 1 to 2 years depending on scooter use and |
|
| conditions. Replace only with a Razor replacement battery. |
| Brakes are not adjusted properly | Refer to adjusting the brakes instructions on page 4. |
|
|
|
Scooter runs sluggishly | Riding conditions are too stressful | Use only on solid, flat, clean and dry surfaces such as pavement or |
|
| level ground. |
| Tire is not properly inflated | The tire is inflated when shipped, but it invariably will lose some |
|
| pressure between the point of manufacturing and your purchase. |
|
| Refer to instructions on page 3 of this manual to properly inflate tire. |
| Scooter is overloaded | Make sure you do not overload the scooter by allowing more than |
|
| one rider at a time, exceeding the electric scooters 120 pounds (54kg) |
|
| maximum weight limit, going up a hill or towing objects behind the |
|
| scooter. If the scooter is overloaded, the circuit breaker may trip and |
|
| shut off power to the motor. Correct the riding conditions that caused |
|
| the overload, wait a few seconds, and then push the breaker to reset |
|
| the circuit. Avoid repeatedly tripping the circuit breaker. |
| Brake dragging | Use your fingers to twist the adjuster in either direction until front |
|
| wheel is centered between pads. |
| Brakes are not adjusted properly | Refer to adjusting the brakes instructions on page 4. |
|
|
|
7