Schwinn Motor Scooters 50GR06SV Throttle Right Handlebar Grip, Brakes, Kick Starter, Center Stand

Page 9

Description of Features, continued

THROTTLE (RIGHT HANDLEBAR GRIP)

ACCELERATE: Twist the throttle toward you.

DECELERATE: Twist the throttle away from you or loosen your grip and the throttle setting will automatically return to idle.

BRAKES

FRONT BRAKE LEVER: The FRONT brake lever is attached to the RIGHT handlebar.

REAR BRAKE LEVER: The REAR brake lever is attached to the LEFT handlebar.

For more information about using the brakes, see “Riding the Scooter”, page 10. To adjust brakes, see “Front and Rear Brake Adjustment” on page 12.

KICK STARTER

Use the kick starter to start the scooter or prime the engine in the following situations:

-If the scooter has been driven less than 100 miles (160 kilometers).

-In cold or wet weather.

-If the fuel tank has run completely dry (and more fuel has been added).

-If the scooter has been stored for more than two weeks.

-If the scooter fails to start using the electric starter button.

-If the battery is discharged.

The kick starter can be used to “prime” the fuel system prior to using the electric start button. See “Starting the Scooter”, pages 8 and 9 for detailed instructions on using the kick starter.

CENTER STAND

Always use the center stand on level ground.

To extend the center stand and park the scooter, grasp the left handlebar grip and the luggage rack with your right hand. Place your right foot on the foot peg of the center stand and push straight down. The rear wheel will raise slightly as the scooter comes to rest on the center stand.

To retract the center stand, grasp both handlebar grips and push the scooter forward. NOTE: Be sure your feet and legs are clear of the center stand. The center stand has a strong spring and will retract under the scooter very quickly.

LUGGAGE RACK

WARNING

Maximum load for the luggage rack is 10 lbs. (4.5 kg). NEVER exceed maximum load capacity for the scooter. Combined weight of the rider, gear and any accessories must never exceed maximum load capacity of 225 lbs. (102 kg). Overloading can impair the stability and performance of the scooter, possibly causing an accident.

Evenly distribute the load on the luggage rack and secure with straps.

Do not attach anything to the handlebars, fenders or footrests.

VIN BADGE AND ACCESS PLATE

You will need your Vehicle Identification Number when registering your scooter with your local government or contacting your dealer. The VIN appears in two places: on the VIN badge, located on the back side of the front fairing, and under the VIN access plate.

AUTOMATIC TRANSMISSION

Your new scooter has an automatic transmission that does not require the use of a clutch or gear shift.

7

Image 9
Contents Gas-powered Scooter Model 50GR06BL and 50GR06SV Table of Contents Safety Precautions SpecificationsIntroduction Vehicle RecordSafety Precautions Wear EYE and Face Protection Wear Protective ClothingStay Visible on the Road Controls FeaturesInstrumentation KEY, Ignition SWITCH, Steering LOCK, Seat Lock and Fuel CAP Description of FeaturesEngine Stop Switch and Starter Button Right Handlebar Headlight and Turn Signal Left HandlebarThrottle Right Handlebar Grip VIN Badge and Access PlateBrakes Kick StarterStarting the Scooter Before Every RideElectric Start Automatic Choke Kick StartRiding the Scooter Breaking In the ScooterRoutine Care and Maintenance Tire MaintenanceRefueling Check Rear Drum Brake Shoe Wear Rear Drum Brake AdjustmentCheck Front Disc Brake Fluid Level Check Front Disc Brake PAD WearChanging the Engine OIL Adding Engine OILAdding Transmission OIL Changing Transmission OILInspecting the Battery Terminals Battery MaintenanceReplacing the Battery Battery DisposalCleaning or Replacing the AIR Filter Replacing the FuseReplacing the Spark Plug Troubleshooting Reporting Safety DefectsCleaning Professional Maintenance Schedule Emissions Performance Warranty Limited WarrantyScooter Noise Regulation Exhaust system Intake System