Panasonic CW-XC184HU Ventilation, Air Direction, How to Secure the Drain Pipe, OptionalCW3H02502C

About the Controls on the Air Conditioner

Additional controls and important information.

Ventilation

The ventilation lever must be in the CLOSE position in order to maintain the best cooling conditions.

When fresh air is necessary in the room, set the ventilation lever to the OPEN position.

The damper is opened and room air is drawn out.

NOTE: Before using the ventilation feature, and prior to installing the front grille, pull down part until level with part .

Air Direction

CLOSE VENT OPEN

Part B

Part A

The direction of air can be controlled wherever you want to cool by adjusting the horizontal louver and the vertical louver.

• VERTICAL AIR-DIRECTION CONTROL • HORIZONTAL AIR-DIRECTION CONTROL

The vertical air direction is adjusted by rotating the	The horizontal air direction is adjusted by
horizontal louver forward or backward manually.	rotating the vertical louver right or left by
	Remote Controller.

How to Secure the Drain Pipe

In humid weather, excess water may cause the BASE PAN to overflow. To drain the water, remove the DRAIN CAP and secure the DRAIN PIPE to the rear hole of the BASE PAN. Press the drain pipe into the hole by pushing down and away from the fins to avoid injury. (See Fig.1)

Optional(CW3H02502C)
1.	Remove the rubber plug and slide the chassis out
	from the cabinet. (See Fig.2)	Drain pipe
2.	Install the drain pan over the corner of the cabinet		Drain cap	Fig. 1
	where you removed the plug with 4 screws.
	(See Fig.3)
3.	Connect the drain hose to the outlet located at the
	bottom of the drain pan. You can purchase the drain		Remove the
			rubber plug	Fig. 2
	hose or tubing locally to satisfy your particular
	needs. (Drain hose is not supplied). (See Fig.3)	CABINET
4.	Select the most appropriate connection from among
	the figures to the right (by considering the hole of the	PAN	Inside diameter 17mm (5/8")
		DRAIN	DRAIN HOSE
	unit) to fit drain pan to your own unit. (See Fig.3)		SCREW	Fig. 3
5.	Slide the chassis back into the cabinet. Reinstall the
	cabinet screws. Secure the cabinet to chassis by
	using screws. (See Fig.4)
				Fig. 4

6