A S S E M B L Y, Initial Assembly, Seat Installation

I V . A S S E M B L Y

INITIAL ASSEMBLY

Your power chair may require some assembly either before initial use or after transportation. It may also require disassembly to make some comfort adjustments. Figure 10 details those parts of the power chair that are designed to be disassembled and assembled by an end user or by a qualified caregiver before using the product or making comfort adjustments.

NOTE: Any nylon insert lock nut removed during the disassembly or adjustment of the power chair must be replaced with a new nut. Nylon insert lock nuts should not be reused as it may cause damage to the nylon insert, resulting in a less secure fit. Replacement nylon insert lock nuts are available at local hardware stores or through your Quantum Rehab Provider.

ARMREST ANGLE ADJUSTMENT

SEAT INSTALLATION

SEAT HEIGHT/ANGLE ADJUSTMENT

CONTROLLER POSITION

FOOT PLATFORM

ANGLE ADJUSTMENT

FOOT PLATFORM HEIGHT/DEPTH ADJUSTMENT

Figure 10. Quantum 610 Series Assembly View (Universal Mounting System Shown)

Seat Installation

It may be necessary to install the seat either prior to initial operation or after transporting your power chair. Most seats are attached to the power base with the Uni- versal Mounting System (UMS). The UMS consists of universal parts that may be attached to any medium- back or high-back seat, regardless of seat width or seat depth. The two main components are aluminum extru- sions mounted to the seat base. These extrusions attach to a pair of trapeze bars that are mounted to the power base. See figure 11.

NOTE: If your power chair is equipped with a Spe- cialty Seat, Synergy Seat, or a TRU-Balance Power Positioning System, refer to the information provided in separate manuals.

WARNING! Do not pick up the seat frame by the armrests. They are free to pivot, and you may lose control of the seat if they do so.

To install the seat:

1. Tilt the seat back and slide the rear extrusion onto the rear trapeze bar. See figure 11.

2. Lower the front extrusion onto the front trapeze bar until the seat locks into place.

3. Flip the seat latch safety down. See figure 11.

WARNING! Make sure the seat latch safety is flipped down before using your power chair.

4.Install the controller and route the harness to the back of the power base. See figure 12.

5.Loosen the rear shroud fasteners and remove the rear shroud. See figure 6.

6.Plug the controller connector into the power base.

See figure 7.

7.Reinstall the rear shroud and tighten the rear shroud fasteners. See figure 6.

8.Route the controller harness so that it cannot be pinched in the seat hinge.

MANDATORY! Prevent controller harness damage! Use correct tie-down points for controller harness. Avoid routing the controller harness on the outside of the armrest pad. Route the harness under the armrest or toward the inside of the armrest pad. Use correct tie-down points for the controller harness to prevent the harness from getting caught in the drive tires, pinched in the seat frame, or damaged when passing through doorways.

9.Secure the controller harness to the armrest receiver with wire ties. See figure 13.

REAR

EXTRUSION

SEAT LATCH

SAFETY

REAR TRAPEZE

BAR

Figure 11. Universal Mounting System

Figure 12. Controller Routed on a Synergy Seat

Quantum 610 Series

www.pridemobility.com

Quantum 610 Series