FPC-11 BATTERY INSTALLATION (PHFW-1118/PHFW-1120)
Battery Baskets
Battery Lids w/ Cables
Using the two 10mm wrenches, bolt the battery cables to battery terminals.
*MATCH COLORS ACCORDINGLY!*
Battery Basket Supports
Battery Strap w/ Buckle
Battery Strap w/o Buckle
Once all batteries cables | Place each assembled battery into |
are attached securely… | each battery basket. Secure the |
| battery to the basket using the |
| battery strap w/ the buckle and |
| tighten securely. |
…Secure each lid using the strap w/o the buckle.
1) Be sure the Powerchair is fully open. From the front
|
| of the unit push down on the right and left seat |
|
| edges. If necessary, from the back of the unit finish |
|
| opening the unit by pushing the battery basket |
|
| supports outwards until the gap is wide enough for |
|
| the battery baskets to slide into the supports. You |
|
| can see that the unit is fully open by looking at the |
|
| drive wheels, verifying that they are perfectly vertical |
|
| (straight up and down) and not slanted. |
|
| 2) Slide the battery basket with the black connector in |
|
| first and connect the black battery connector to the |
|
| black connector secured to the left front part of the |
|
| frame. Next, slide the battery basket with the red |
|
| connector in and connect to the red connector |
|
| secured to the left rear part of the frame. |
6/25/2004 | 21 | 3) Make sure to charge battery fully for |
first initial use |