SCOOTER TILLER CONTROLS (FIG 3)
Speed Controls
The speed control allows you to set a speed between 1 (minimum) and 10 (maximum). There is also a high/low switch giving you a total of 20 speed settings..
Battery Level Indicator
The number of red bars shows the amount of charge left in your batteries. The amount of charge will only show at its true level when the scooter is in drive.
Speed
Controls
Indicator
Switch
Finger
Lever
Control
Horn 
Battery
Level Speed
Indicator High/Low
Switch
Hazard
Lights
Lights
Key
Switch
Caution – Do not allow the battery | Figure 2 |
level indicator to go down |
|
completely as complete discharge |
|
of the batteries could cause irreversible damage. |
|
Horn |
|
A yellow button at the rear of the tiller operates the horn. |
|
Hand Lever Controls
The right hand lever controls the forward motion and the left hand lever controls the reverse motion. The amount of pressure applied to each lever will determine the speed the scooter travels, up to the speed designated with the speed dial. Release the lever and the scooter will automatically come to a stop as the electromagnetic brake is applied to the motor.
On/Off Key Switch
Insert the key in the right side of the tiller. Turn the key and the battery light indicator will light up. There may be a slight delay before the hand lever control can be operated, while the controller checks the circuits.
Electromagnetic Brake
The brake is automatically operated when the control levers are pressed or released. There is a slight delay when the scooter decelerates; this allows the scooter to come to a smooth stop.
7/3/2006 | - 8 - |