Wheels and Tires, Trouble Shooting Guide

Wheels and Tires

The wheels of your scooter all have split rims. This allows any punctures to be repaired easily. To change the wheels remove the center bolt and slide the wheel off its axle. Ensure that when refitting the wheel the retaining bolt is fitted with a locking washer or the screw threads are treated with lock-tite or a similar adhesive. When changing a tire the inner tube must be deflated. Remove the four bolts from the wheel and split the rim. Tire pressure is recommended to be kept at 30 psi on the rear tires, and 25 psi on the front.

TROUBLE SHOOTING GUIDE

Circuit Breaker

Your scooter is fitted with the latest in electronic controls that are programmed to protect the electrical system from abnormal overloads. Fitted for extra protection is a circuit breaker, should there be a situation that your scooter stops for no apparent reason please check that the circuit breaker has not popped out. The circuit breaker can be found under the rear chassis cover accessible through a port hole under the seat.

Check List

If your scooter fails to operate, please check the following:

•Unit is switched on.

•All plugs and connectors are firmly fixed.

•Battery level shows full charge.

•Freewheeling device is in the drive position.

If the free wheel device has been operated with the scooter left switched on, then the scooter will not operate until the ignition key has been switched off and then on again.

Please consult your provider if your scooter does not run after checking these points.

5/11/2004