Shoprider 858WM guide

6Runner 888WNLM,858WM, 888WNLLHD How to Charge Your Unit

1)Plug the A/C power cord into the wall. Plug the male three-pin charger plug into the female 3-pin receiver located on the bottom of the VSI. Turn the switch on if applicable (8Amp charger only)

The battery charger’s light indicator is as follows:

One light charger (4Amp)

Yellow/Amber-	Charging
Green-	Charging Complete

Two light charger (8Amp)

Red (solid)-	Power ON
Yellow/Amber-	Charging
Green-	Charged

NOTE: It is very important to check the charger light color. If there is no light or a different color light on than should be, refer to the charging trouble shooting section in this manual.

Depending on the amount of battery discharge, the charge time can take up to 12 hours. The battery charger has an electronic switch that will terminate the charge when the batteries are fully charged. Do not remove the battery charger until the charging cycle is complete. Be sure to unplug charger from the wall first before unplugging charger from the Powerchair.

WARNING! Only use the original manufacturer approved charger!

This charger is for indoor use only. Do not expose it to rain or water spray.

Do not leave the charger plugged into the Charging Port if the charger is not charging.

3/28/2008