BASIC TROUBLESHOOTING INSTRUCTIONS: JAZZY SELECT 14
What if my Jazzy Select 14 begins pulling to one side?
!Determine if the joystick is being deflected straight or at a slight angle. Even a small amount of deflection right or left will cause the chair to veer over a long distance.
!Determine if both manual freewheel levers are in the drive position. If only one manual freewheel lever is in the drive position, the other motor will not operate and the Jazzy Select 14 will veer severely.
!Determine if both tires are inflated to the proper psi if the power chair is equipped with pneumatic tires. Pneumatic tires should be inflated to 35 psi (2.4 bar). If one tire is inflated more than the other, the power chair will pull to the side that is underinflated.
What if the Jazzy Select 14 powers up, but will not move?
!Determine if both manual freewheel levers are in the freewheel position. If the power chair is in freewheel mode, then the electronics will function but the motors will not spin the wheels.
!Determine if the controller is flashing a fault code. The Jazzy Select 14 comes equipped with a VSI or VR2 controller. Both controllers will flash a code via the battery condition meter LEDs if a system fault is detected.
VSI DIAGNOSTIC FLASH CODES
# OF LEDS | CODE | CAUSE | POSSIBLE SOLUTION |
One red LED | 1 | Low battery voltage | Charge batteries |
|
|
|
|
Two red LEDs | 2 | Left motor open | Make sure left motor is plugged into controller. |
Three red LEDs | 3 | Left motor wiring fault | Contact your authorized Pride Provider. |
Three red LEDs | 4 | Right motor open | Make sure right motor is plugged into controller. |
One yellow LED |
|
|
|
|
|
|
|
Three red LEDs | 5 | Right motor wiring fault | Contact your authorized Pride Provider. |
Two yellow LEDs |
|
|
|
|
|
|
|
Three red LEDs | 6 | Inhibit active | Contact your authorized Pride Provider. |
Three yellow LEDs |
|
|
|
Three red LEDs | 7 | Joystick error | Contact your authorized Pride Provider. |
Four yellow LEDs |
|
|
|
|
|
|
|
Three red LEDs | 8 | Controller error | Contact your authorized Pride Provider. |
Four yellow LEDs |
|
|
|
One green LED |
|
|
|
Three red LEDs | 9 | Brake fault | Make sure both motors are plugged into controller. |
Four yellow LEDs |
|
|
|
Two green LEDs |
|
|
|
|
|
|
|
Three red LEDs | 10 | High battery voltage | Contact your authorized Pride Provider. |
Four yellow LEDs |
|
|
|
Three green LEDs |
|
|
|
|
|
|
|
INFINFB2048/Rev | www.pridemobility.com | 2 |