V . C O M F O R T A D J U S T M E N T S
COMFORT ADJUSTMENTS
After becoming familiar with your power chair’s operation, you may find the need to make some adjustments to increase your comfort, such as seat height and angle, armrest angle, foot platform height and angle, and controller position.
NOTE: If your power chair is equipped with a Specialty Seat, Synergy Seat, or
WARNING! The center of gravity of your power chair was factory set to a position that meets the needs of the demographic majority of users. Your authorized Pride Provider has evaluated your power chair and made any necessary adjustments to suit your specific requirements. Do not change your seating configuration without first contacting Pride Mobility Products or your authorized Pride Provider.
WARNING! Some power chair components are heavy. You may need assistance to lift or carry them. Please refer to the specifications table for specific component weights before you disassemble the power chair.
WARNING! Remove the occupant from the power chair before making any adjustments.
You may need the following to make comfort adjustments:
metric/standard socket set and ratchet adjustable wrench
thread lock
Seat Height and Seat Angle Adjustment
You can change the seat height to one of four positions by raising the front and rear trapeze bars. If you raise or lower only one trapeze bar (front or rear), you can also change the seat base angle (dump).
Figure 14. Seat Height Adjustment - Seat Latch Safety
To change the seat height:
1.Turn off the power to the controller.
2.Gently push down and pull backward at the harness access point on the rear shroud until it releases. See figure 12.
3.Disconnect the controller connector(s) from the power base. See figure 7.
4.Flip up the seat latch safety. See figure 14.
5.Squeeze the seat latch and release the seat from the front trapeze bar.
6.Slide the seat forward and remove it from the power base.
7.Loosen the screws that attach the trapeze bars to the seat posts. See figure 15.
8.Remove the retaining clips that secure the seat posts to the power base. See figure 15.
9.Move the trapeze bars up or down to the desired height.
NOTE: Change the seat dump by raising or lowering only one set of towers (front or back).
SCREWS | TRAPEZE BARS |
SEAT POSTS | RETAINING CLIPS |
|
Figure 15. Seat Adjustment - Trapeze Bars
Jazzy 600 Series | www.pridemobility.com | 23 |